10L0L 48V Golf Cart Solenoid for Club Car DS (1995–1997) 4‑Terminal Direct-Fit OEM 101807001

This 10L0L solenoid is a direct-fit electrical switch for the drive circuit of 48‑volt Club Car DS golf carts from the 1995–1997 production years. It replaces the original OEM part numbers 101807001 and 1118 and replicates the four-terminal layout used on those carts. The unit simplifies repair with a straightforward pull-and-replace installation and targets reliable contact switching between battery packs and the motor controller when the cart is engaged.

How will this solenoid fit my 1995–1997 Club Car DS?

The part is engineered to match the mounting points, terminal arrangement, and electrical function of the original solenoid used in those model years. You should find the bolt pattern and terminal spacing aligns with the factory location, so no custom brackets are generally required.

• Designed for 48V Club Car DS models from 1995–1997
• Replaces OEM part numbers 101807001 and 1118
• Four-terminal layout matches factory wiring harness
• Mounting holes positioned for direct swap

What do I need to know before installing it?

Turn off power and remove battery connections before you begin. The solenoid is installed by removing the old unit and transferring the wiring; it’s intended to be a simple replacement job for anyone comfortable with basic electrical connections.

• Always disconnect battery packs before handling
• Do not use a socket set to tighten terminals—follow torque guidance below
• Transfer existing cables to matching terminals to preserve polarity
• Test operation before reassembling panels

How should I secure the fasteners for the best long‑term reliability?

Terminals should be snug but not overtightened. The recommendation is to make nuts hand tight and then add a 1/4 turn with a wrench; this minimizes thread damage and helps maintain conductivity over repeated thermal cycles.

• Tighten nuts by hand first, then 1/4 turn with a wrench
• Avoid using impact tools or heavy socket torque
• Inspect and recheck terminal tightness periodically
• Loose nuts can cause heating and poor connection—check often

What common maintenance tips should I follow after fitting this solenoid?

After installation, periodically inspect the terminal connections and mounting hardware. Corrosion or vibration can loosen connections over time, so keeping fasteners checked ensures consistent electrical contact and avoids intermittent performance.

• Inspect nuts and wiring every few months or after rough terrain use
• Keep terminals clean and free of corrosion for best conductivity
• Replace frayed or damaged battery cables when discovered
• Verify cart engages and disengages smoothly after maintenance

Who is this for: Technicians, fleet managers, and DIY golf cart owners who need a direct OEM‑replacement 48V solenoid for 1995–1997 Club Car DS carts. It’s ideal for anyone wanting a plug‑and‑play swap that preserves the original 4‑terminal wiring layout while following recommended installation practices to maintain reliable electrical performance.