A-Premium Front Right CV Axle Shaft for Nissan Altima 2013–2018 2.5L Sedan — 38.9in, 27/32 Splines

A-Premium Front Right (passenger side) CV axle shaft assembly replaces the worn drive axle on Nissan Altima 2013–2018 L4 2.5L sedans to restore reliable power transfer from the transaxle to the wheel.

This replacement axle is engineered to meet the fitment and spline requirements of specified Nissan Altima models. It’s designed as a direct-fit front right (passenger) shaft with the correct spline counts, compressed length, and spindle nut thread size so you can swap it in without modifying surrounding components. The assembly comes ready with the axle nut included and is backed by A-Premium’s one-year unlimited-mileage warranty to provide extra confidence after installation.

Which vehicles and model years does this CV axle fit?

This axle is intended specifically for Nissan Altima sedans with the L4 2.5L engine built from 2013 through 2018. It is for the front right (passenger) side only and is not compatible with coupe or non-L4 configurations unless specified by the vehicle’s OEM references.

• Compatible: Nissan Altima 2013–2018 with 2.5L L4 engine (sedan only)
• Not compatible: Coupe models or different engine sizes without verification
• Reference part numbers: 391003NT0A, NCV53018, 666431, 66-6431

What are the important specifications to check before buying?

Confirming critical measurements prevents fitment problems during installation. This axle lists both input and output spline counts, compressed length, and the correct spindle nut thread so it matches the vehicle’s hub, transmission, and steering knuckle interfaces.

• Location: Front right (passenger side)
• Compressed length: 38.9 inches for correct reach and tension
• Input spline count: 27; Output spline count: 32
• Spindle nut thread: M24 x 1.5; axle nut is included
• ABS ring: Not included — verify if your vehicle requires it

How does this CV axle perform and what does it include?

This assembly transfers torque from the vehicle’s transmission/differential to the wheel while allowing for steering and suspension movement. The unit arrives as a pre-assembled shaft with the required axle nut; it is ready for installation where a direct-fit replacement is called for.

• Function: delivers engine power to the wheel while accommodating suspension motion
• Comes with axle nut; spindle nut thread size matches OEM specification
• ABS ring excluded — check vehicle hub for ABS sensor tone ring needs
• Backed by a one-year unlimited-mileage A-Premium warranty

What should I consider during installation and maintenance?

Installers should ensure correct torque values for the axle and spindle nuts and inspect surrounding components like wheel bearings and CV boots for damage. Use OEM torque specs and consider replacing torn boots or corroded hardware to maximize service life of the new axle.

• Verify vehicle compatibility via VIN or OEM part cross-reference
• Use proper torque specs for M24 x 1.5 spindle nut and axle nut
• Inspect CV boots, hub bearings, and suspension components before reassembly
• If ABS tone ring is required, confirm sensor alignment and presence

Who is this for: This A-Premium front right CV axle shaft assembly is aimed at DIY mechanics, independent shops, and fleet service technicians repairing Nissan Altima 2013–2018 sedans with the 2.5L L4 engine who need a direct-fit replacement. If your vehicle shows torn CV boots, clicking noises while turning, vibration, or a failed axle inspection and the fit data matches your VIN, this axle provides the correct spline counts, compressed length, and thread size to restore driveline function with minimal fuss.