ALL-CARB 15004 Carburetor Replacement for Kawasaki FX850V and FH Engines — Kit with Gaskets & Fuel Filter

ALL-CARB 15004 is a direct-replacement carburetor assembly designed to replace Kawasaki part numbers 15004-1018, 15004-0865 and 15004-0941 for FX850V and compatible FH engines.

If your Kawasaki engine is running rough, hard to start, or showing fuel-related performance issues, swapping in a correct replacement carburetor often restores reliable operation. The ALL-CARB 15004 kit ships with the carburetor plus gaskets and a fuel filter so you can complete the installation without sourcing extra small parts. Before buying, compare the physical appearance and mounting points to your original carb to ensure a proper fit.

How does this replacement carburetor match Kawasaki part numbers?

This ALL-CARB unit is built to be a compatible replacement for several Kawasaki carburetor numbers including 15004-1018 and earlier OEM references. It follows the mounting pattern, throttle linkage geometry, and fuel inlet placement used on the FX850V and select FH series engines to ensure interchangeability. Minor adjustments such as idle or mixture screw tuning may be required after installation.

• Directly replaces 15004-1018, 15004-0865 and 15004-0941 numbers
• Compatible with FX850V and many FH641V/FH661V/FH680V series models
• Same inlet and throttle linkage layout for straightforward swap

What comes in the package and what do I need for installation?

The kit arrives with the carburetor, seven gaskets to seal the mating surfaces, and a replacement fuel filter to protect the bowl and jets. Standard hand tools are typically all that’s required for removal and installation, plus a clean rag and a small container for draining fuel. Keep the old carb and linkages available to confirm alignment and any vacuum line connections.

• Included: 1 carburetor, 7 gaskets, 1 fuel filter
• Recommended tools: screwdrivers, socket set, pliers, drain container
• Tips: compare gaskets and bolt pattern before tightening

Will I need to tune or adjust anything after fitting this carb?

After installation, basic tuning such as adjusting the idle speed and mixture screws is normal to achieve smooth running across load ranges. Environmental factors like altitude and fuel grade influence jetting needs; if the engine runs too lean or rich under load, small jet or needle adjustments may be necessary. Follow Kawasaki or engine-specific service guidelines for final tuning and verify throttle linkage free play.

• Adjust idle speed and mixture screws after installation
• Check throttle linkage free travel and choke operation
• Consider professional jetting if running conditions demand it

How do I confirm compatibility with my mower or engine model?

Compare the photos, mounting flange, and fuel inlet location of this ALL-CARB unit to your existing carburetor before ordering. Cross-reference the engine model (FX850V, FH641V, FH661V, FH680V, etc.) and any OEM part numbers stamped on your old part. If the bolt pattern, linkage orientation, and bowl shape match, the replacement should fit and function as intended.

• Match bolt pattern, throttle linkage, and fuel inlet placement
• Confirm engine model and OEM part numbers on the old carb
• Contact support if photos or measurements are unclear

Who is this for: The ALL-CARB 15004 replacement is aimed at owners, repair shops, and maintenance technicians who work on Kawasaki FX850V and related FH-series engines and need a ready-to-install carburetor kit. It’s useful for routine maintenance, restoring performance on older equipment, or completing a field repair with minimal downtime. If you value a complete kit with gaskets and a fuel filter so you can finish the job in one visit, this product is intended for you.