AUGREX DA-4 OBDII Cable Adapter for Snap-on Solus Ultra (EESC318) — 6ft Shielded Lead, 26-pin to 16-pin

The AUGREX DA-4 OBDII cable adaptor is a heavy-duty 6-foot lead that converts the 26-pin connector on Snap-on Solus Ultra EESC318-compatible scan tools to a standard 16-pin OBD2 plug for reliable vehicle diagnostics.

This aftermarket DA-4-style cable lets you link a Solus Ultra (EESC318-compatible) scanner to an OBD-II port when your original Snap-on cable is lost, damaged, or you need an extra lead. Built with thick shielding and molded connectors, it’s designed to reduce interference and withstand workshop use while matching the pin configuration required for Solus Ultra DA-4 operation. Note: this cable is made by AUGREX and is not an official Snap-on part; confirm your scanner model before purchase.

Will this cable fit my Snap-on Solus Ultra (EESC318) scanner?

Yes — when your tool uses the DA-4-style 26-pin female interface, this adaptor plugs into that port and provides a standard 16-pin male OBD2 connection to the vehicle. Check the scanner’s labeling or manual for the DA-4 compatibility and the listed Snap-on part numbers it replaces.

• Replaces Snap-on EAX0068L00C and EAX0068L26A part numbers
• 26-pin female to 16-pin male OBD2 pinout matching Solus Ultra DA-4 requirements
• Confirm scanner model EESC318 or DA-4 compatibility before ordering

How durable and reliable is the AUGREX DA-4 OBDII cable?

The cable is built for workshop environments with a thick, shielded jacket and heavy molded ends to resist wear, bending, and electrical interference. Its design prioritizes signal stability during tests, helping maintain consistent communication between the scanner and vehicle control modules.

• Heavy-duty thick-shielded cable construction for noise reduction
• Molded strain-relief ends to prevent connector failures
• 6-foot length offers flexible reach around most vehicles

What exactly are the connector types and cable length?

This adaptor features a 26-pin female connector that mates with DA-4-compatible Solus Ultra scanners and terminates in a standard 16-pin male OBD2 plug for the vehicle side. The six-foot lead provides ample reach for engine bay and under-dash diagnostics without pulling the scanner close to the car.

• 26-pin female (scanner side) to 16-pin male OBD2 (vehicle side)
• Cable length: 6 feet (approximately 1.8 meters)
• Pin mapping designed for DA-4 Solus Ultra functionality

Are there installation tips or compatibility cautions?

Installation is plug-and-play when your scanner uses the DA-4 style interface: connect the 26-pin end to the scanner and the 16-pin to the vehicle OBD2 port. Always power the scanner and verify communication; if the tool can’t connect, double-check model compatibility and the indicated part numbers.

• Ensure scanner model matches EESC318/DA-4 compatibility
• Inspect connectors for dirt or bent pins before use
• Not an OEM Snap-on cable — confirm replacement part numbers listed

Who is this for: Technicians, DIY mechanics, and service shops that use Snap-on Solus Ultra (EESC318/DA-4 compatible) scanners and need a rugged, reliable replacement or spare OBD-II lead. If you require workshop-grade shielding, a 6-foot reach, and precise pinout compatibility with DA-4 scanners, this AUGREX cable is a practical, cost-effective alternative to sourcing OEM parts.