DABAZUALY Ignition Coil Module 2-Pack for Kohler CH18 CH20 CV18 CV20 CV23 — restores spark and starting reliability

High-performance replacement ignition coil module (2-pack) for Kohler Command Pro twin-cylinder engines that restores spark delivery and engine starting reliability.

If your Kohler CH18, CV18, CH20, CV20, CV23 or similar Command Pro twin-cylinder engine is misfiring, hard to start, or running unevenly, a worn or failed ignition coil module is a common cause. This DABAZUALY two-pack includes compatible modules listed under factory and aftermarket part numbers including 24 584 01-S, 24 584 45-S, and 24 584 201-S, making it a practical kit for small-engine maintenance and quick replacement projects.

Which engines and models does this coil module fit?

This ignition coil module is designed for Kohler Command Pro twin-cylinder engines and cross-references numerous model codes. It fits a wide range of factory model numbers across CH and CV series, and it also replaces related part numbers used in some John Deere and aftermarket applications.

• Direct fit for Kohler CH18, CV18, CH20, CV20, CV23 Command Pro twin-cylinder engines.
• Compatible with engine model suffixes such as CH730, CH620, CH640 series listed by Kohler.
• Cross-replaces part numbers: 24 584 01-S, 24 584 45-S, 24 584 201-S, 28 584 02-S and equivalents.
• Works as a replacement option where John Deere part numbers MIU11542 and M132370 are referenced.

How will replacing the coil module affect engine performance?

Installing fresh coil modules can restore consistent spark timing and cylinder firing, which improves idle stability, throttle response and starting reliability. Replacing both modules at the same time reduces future troubleshooting and helps maintain balanced output across both cylinders.

• Eliminates intermittent misfires caused by weakened coils or internal shorts.
• Improves cold-start ignition and reduces extended cranking time.
• Promotes even cylinder power to reduce vibration under load.
• Two-piece kit allows replacing both cylinder coils together for symmetry.

What should I check before ordering and installing these coils?

Confirm compatibility with your engine model and part numbers, inspect the existing ignition wiring and spark plugs, and ensure the engine is powered down and cooled before any work. If the engine has damaged plug wires, connectors, or a faulty flywheel magneto, replacing the coil alone may not resolve the problem.

• Verify your engine model code matches the supported Kohler CH/CV listings.
• Compare old part numbers (24 584 01-S, 24 584 45-S, etc.) to the kit’s references.
• Check plug gap, spark plug condition, and coil mounting points for corrosion or damage.
• Use recommended torque on mounting hardware and route wires away from heat sources.

How do I install the replacement module safely and correctly?

Installation is straightforward for someone comfortable with small-engine maintenance: disconnect the battery or power source, remove engine covers, unfasten the failed module, and swap in the new unit while matching wire positions. Reassemble carefully and test-start the engine while observing for smooth operation.

• Always disconnect spark-plug leads and battery before beginning work.
• Label or photograph connector positions to ensure correct reassembly.
• Mount the module securely and protect terminal connections with dielectric grease if exposed.
• Run the engine at idle after install to confirm even firing and absence of misfire.

Who this is for: This 2-pack from DABAZUALY is made for homeowners, landscapers, small-engine mechanics and fleet maintainers who service Kohler Command Pro twin-cylinder engines and want a reliable, cost-effective ignition coil replacement. Choose this kit if you need direct-fit parts that cross-reference common Kohler and aftermarket numbers and prefer replacing both coils at once to reduce repeat service visits.