Euplokeer RV Gas Struts 20in Pair (20 lb / 89N) with Brackets — Replacement Lift Supports for RV Doors, Hatches

Euplokeer Qty 2 20-inch gas struts are a ready-to-install pair of 20 lb (≈89 N) lift supports with brackets for RV doors, bed platforms, boat hatches and camper shells.

These two gas springs provide a compact, durable solution when replacing worn or weak lift supports on mobile and marine access panels. Each cylinder extends to 20.00 inches and delivers roughly 20 pounds of push force, and the kit includes both L-style and flat-bottom mounting brackets plus screws to simplify fitment for many common OEM interchange numbers. The unit is intended as a mechanical convenience component to steady and assist doors and lids during opening and closing.

How do I know these gas struts will fit my RV or hatch?

Match three basic details from your existing strut to ensure compatibility: the extended length, the pound-force rating, and any OEM part or interchange number stamped on the cylinder. This Euplokeer set lists common equivalents so you can compare directly with your original part.

• Extended length: 20.00 inches (measured end-to-end when open)
• Force: 20 lb (≈89 N) per strut
• Common interchange numbers: C16-08568, GSNI-5300-20, SE197P20, LGP6-200-20 variants

What comes in the box and how difficult is installation?

The kit includes two gas springs, two L-brackets, two flat-bottom brackets and 16 screws for assorted mounting options. Installation is straightforward for anyone comfortable with basic hand tools — no special equipment is required beyond a screwdriver and possibly a wrench to remove old ball-stud fittings.

• 2 gas struts, pre-charged, 20 in extended length
• 2 L-shaped brackets and 2 flat-bottom brackets for varied mounting angles
• 16 mounting screws and simple end fittings for ball-stud attachment

How should I select force and measure for correct operation?

Pick a gas strut force that balances the weight and leverage of the door or lid: too weak won’t support the load, too strong may make lowering difficult. Measure the extended length from center of mounting hole to center of the opposite mounting hole on your current strut and confirm the pound rating printed on the OEM part.

• Measure with the part fully extended for accurate length
• Use OEM pound rating or match similar-sized original cylinders
• Consider door hinge position and intended assist (full lift vs. gentle hold)

What maintenance or care does the Euplokeer gas spring need?

These gas struts are low-maintenance mechanical parts; keep the piston rod clean and avoid painting or applying grease that attracts dirt. Check mounting brackets and fasteners periodically for tightness and replace a strut if it shows leaks, significant rust, or a loss of lift performance.

• Wipe piston rod clean—no lubricants that trap grit
• Tighten mounting screws and inspect ball studs yearly
• Store spares upright in a dry place to preserve seals

Who is this for? This Euplokeer 20-inch, 20 lb gas strut pair is designed for DIYers, RV and boat owners, and mobile-workshop builders replacing tired lift supports on entry doors, storage compartments, camper shells, hatches, or fold-up bed platforms. It suits anyone who prefers a straightforward replacement with included mounting hardware, common OE cross-references, and accessible customer support for installation questions and aftercare.