iKer Body Mount Bushing Kit for Ford F250 F350 2008-2016 KF04060BK — Polyurethane bushings & steel cups

If your Super Duty shows body sag, excessive vibration, or uneven gaps between cab and frame, this replacement kit gives you the matched bushings, steel cups, washers, and hardware needed for a full service. The kit includes polyurethane bushings in two sizes, small and large steel mounts, two special body mounts, washers, and a hardware pack to restore factory ride height and reduce movement between the cab and frame.

What parts are included, and why does each matter?

The KF04060BK kit is bundled to address every mounting point commonly serviced during a body mount refresh. Each component works together to re-establish secure contact and proper spacing between the cab and chassis.

• 8 × M04060-02 and 8 × M04060-01 polyurethane body mounts — replace the primary rubber/urethane isolators.
• 2 × M03306 body mounts — used where a different height or fit is required.
• 8 small steel cups (S22545) and 8 large steel cups (S22319) — seat the bushings and prevent extrusion under load.
• 2 washers (S10126) and hardware kit BP04057 — includes bolts and components to secure mounts to the frame.

How does material choice affect longevity and performance?

iKer uses polyurethane for the bushings, which typically resists oil, ozone and abrasion better than older rubber components. Polyurethane preserves ride height and resists tearing or permanent deformation under heavy loads and towing stresses.

• Polyurethane compound resists cracking and absorbs repeated load cycles.
• Steel cups protect the bushing from compressive damage and maintain alignment.
• Hardware kit included to ensure correct torque and safe installation.

Will this kit fit my truck model and trim?

The kit is designed for Ford Super Duty F250 and F350 model years 2008 through 2016 and fits both 2WD and 4WD configurations. It is compatible with common trims and special editions such as Lariat, Platinum, King Ranch, FX4, XL, XLT, Cabela’s and Harley-Davidson models—always verify fitment with your vehicle details before ordering.

• Fits model years: 2008–2016 for F250 and F350 Super Duty trucks.
• Compatible with 2WD and 4WD drivetrains and most factory trims.
• Confirm your truck’s mounting layout and kit quantities before installation.

What should I know about installation and maintenance?

Installers should take care loosening bolts—they are often thread-locked and may require penetrating lubricant and the correct torque sequence. Inspect frame mounting points for rust or deformation and replace any damaged fasteners; the included hardware kit covers typical needs but inspect what comes off the truck.

• Use penetrating oil and proper tools; do not rush bolt removal to avoid breakage.
• Check frame holes and seat areas for corrosion; clean before installing new cups.
• Torque bolts to manufacturer specifications and recheck after a short road test.

Who this is for: The iKer KF04060BK kit is intended for mechanics, DIY truck owners, and restoration shops working on Ford Super Duty F250/F350 trucks from 2008–2016 who need a comprehensive set of body mounts, steel seats, washers, and hardware to restore cab stability, ride height, and reduce unwanted movement. It is ideal when multiple mount points are worn, when performing a frame-off restoration, or when upgrading old rubber mounts to more durable polyurethane replacements.