JRbuid Kawasaki V-Twin Push Rod & Valve Cover Gasket Kit, 4 Push Rods + 2 Gaskets for FR651V/FR691V/FR730V Engines

JRbuid's two-pack replacement includes four 13116-0725 push rods and two 11061-1285 cover gaskets engineered to restore valve-train alignment and seal the valve-cover area on compatible Kawasaki V-twin engines.

This repair kit supplies the exact part numbers commonly requested for service on Kawasaki FR651V, FR691V, FR730V, FX651V, FX730V and FS-series commercial engines. Whether you're performing routine maintenance or completing a mid-life rebuild, the package gives you the push rods and gaskets needed to address worn push-rod geometry and a leaking cover seal without sourcing parts separately.

Will these parts fit my Kawasaki engine model?

These components are produced to match the referenced OEM part numbers and fit a range of Kawasaki V-twin air-cooled engines. Confirm fitment by comparing your engine's part numbers or model designation with the listing before ordering.

• Includes 4 × 13116-0725 push rods and 2 × 11061-1285 cover gaskets.
• Listed compatibility: FR651V, FX730V, FR691V, FR730V, FS651V, FS691V, FX651V, FS730V.
• Check your engine serial or parts manual to verify exact compatibility.

How do these push rods and gaskets improve engine serviceability?

Replacing worn push rods restores precise valve actuation, reducing valve float and irregular lifter motion. The cover gasket prevents oil seepage around the valve cover, helping maintain correct oil levels and cleanliness in the valve-train area.

• Push rods: restore correct push-rod length and straightness for reliable valve timing.
• Gaskets: provide a new compression seal to stop oil leaks at the cover.
• Sold as a kit to simplify maintenance tasks and minimize parts hunting.

What should I know before installing these parts?

Basic mechanical skill and common hand tools are required—installation involves removing the valve cover and rocker assembly, inspecting related components, then replacing the push rods and gasket. Always follow Kawasaki service procedures and torque specs for reassembly to avoid damage or leaks.

• Drain or contain oil as needed to prevent spills when removing the cover.
• Inspect rocker arms, lifters, and cam surfaces for wear while disassembled.
• Replace bolts and seals per factory torque sequence; use thread locker if recommended by service docs.

What does the package include and where can I get help?

The kit ships with four push rods and two cover gaskets packaged together for immediate use. If you have questions about part fitment or installation, JRbuid offers customer support—reach out before or after purchase for guidance.

• Packaging list: 2 × 11061-1285 gasket, 4 × 13116-0725 push rods.
• Tip: verify your engine model before ordering to ensure correct fitment.
• Customer support: contact JRbuid by email for product questions or assistance.

Who is this for? This kit is intended for small-engine technicians, commercial equipment fleet maintainers, and DIY owners who service Kawasaki FR/FX/FS-series engines and need reliable replacement push rods and valve-cover gaskets. It's particularly useful when performing valve-train inspections, correcting oil leaks at the valve cover, or rebuilding engines where matching OEM part numbers are required. If you prefer buying matched components together to cut downtime and avoid multiple orders, this JRbuid set offers a straightforward, ready-to-install solution.