LIZAPUS 12V 80A Trim & Tilt Relays with Plug Sockets — 2-Pack Compatible with Cook 7493, Protective Skirt

This kit contains two brand-new 12V 80-amp relays (manufacturer part 7493) and two compatible plug sockets designed for trim and tilt assemblies and jack plates made since 1990. The 7493 relay features a protective skirt and is a direct plug-in replacement for the earlier 7312 relay, letting you swap components quickly without rewiring. The kit ships as part number 119-7493 and is supplied ready for installation with standard wiring connections used on many outboard motor and boat lift control systems.

Will these relays fit my existing trim & tilt jack plate?

These relays and sockets are built to match the common jack plate wiring used by manufacturers since 1990 and will plug into the same sockets designed for the 7312 relay. They will not fit sockets that were made specifically for the 7122 relay, so confirm the socket type before ordering. If your system accepted a 7312, the 7493 is a drop-in replacement with the same pin layout.

• Compatibility: fits jack plates and trim & tilts made since 1990
• Direct replacement for: Cook Mfg 7312-style sockets
• Not compatible with: sockets designed for the 7122 relay
• Part numbers: vendor SKU 119-7493, Mfr P/N 7493

How do I install the relay and plug socket?

Installation is straightforward for anyone familiar with trim and tilt electrical systems: unplug the old relay, insert the new relay into the existing socket (if compatible), and secure wiring as required. When adding the supplied sockets, mount them in a dry, accessible location and connect wire terminals per your system diagram. Use proper corrosion protection and verify voltage and ground connections before operation.

• Pre-install check: confirm socket type and system voltage (12V)
• Mounting: position socket in a dry, accessible place
• Wiring: match terminals to existing harness or service manual
• Safety: disconnect power before swapping relays

What performance and protection features does the 7493 relay include?

The 7493 is rated for 12 volts at 80 amps and includes an outer skirt on the relay body to offer additional protection to the terminals and housing. That rating covers typical motor drive and actuator loads in trim/tilt systems, while the skirt helps shield contacts from splashes or brief exposure. The kit supplies two relays and two sockets so both sides of a dual system or a spare can be covered.

• Electrical rating: 12V, 80-amp switching capacity
• Physical feature: protective skirt on relay body
• Packaging: includes 2 relays and 2 plug sockets
• Use case: designed for motor drive and actuator control circuits

Who is this for: technicians, DIY boat owners, and marine service shops replacing or upgrading trim & tilt control relays and sockets will find this LIZAPUS 2-piece kit useful. It suits anyone running 12V jack plate systems that previously used the 7312 relay form factor and who need a straightforward, OEM-style replacement without custom wiring. If you require compatibility with legacy 7122 sockets, check your current relay before purchasing.