NewYall Power Steering Pump for Lexus & Toyota 3.0L/3.3L V6 with M16 x 1.5 Outlet and Preinstalled Pulley

This replacement pump is built for 3.0L and 3.3L V6 models from Lexus and Toyota, offering a like-for-like connection where the steering system requires an M16 x 1.5 outlet. It’s intended as a direct-swap aftermarket option for vehicles including the Lexus ES300 and RX330 plus Toyota Avalon, Camry, Highlander, Sienna, and Solara across the model years shown. The unit ships with the pulley installed and is designed to restore hydraulic pressure and steering assist when the original pump is worn or leaking.

Which Lexus and Toyota engines will this pump fit?

This NewYall pump is matched to several 3.0L and 3.3L V6 applications. Confirm engine displacement and year before ordering to ensure compatibility with your vehicle’s steering system.

• Fits Lexus ES300 (3.0L V6) model years 1997–2001
• Compatible with Lexus RX330 (3.3L V6) model years 2004–2006
• Designed for Toyota Avalon and Camry (3.0L V6) 1995–2004/1995–2006 respectively
• Also fits Toyota Highlander (3.3L V6) 2004–2007, Sienna (3.0L V6) 1998–2003, Solara (3.0L V6) 1999–2003

How do I verify the pump’s outlet connection and fit?

Check the existing pump’s outlet thread and mounting pattern against this unit. The critical measurement is the power steering outlet thread, which for this NewYall pump is M16 x 1.5, a common spec on the listed models.

• Measure outlet thread on your old pump to confirm M16 x 1.5
• Compare pulley diameter and bolt pattern to your belt and mounting bracket
• Match vehicle year and engine code with the compatibility list above

What should I expect during installation and initial use?

Installation generally follows standard steering pump replacement steps: remove the serpentine belt, disconnect lines, unbolt the old unit, then mount and connect the replacement. After installation, bleed the steering system of air and check for leaks and correct belt alignment before road testing.

• Use proper tools to avoid damaging the pulley or fittings
• Refill with manufacturer-recommended power steering fluid and bleed thoroughly
• Inspect hoses and clamps; replace if cracked or corroded for a reliable seal

Will this pump work as a long-term repair or temporary fix?

When installed correctly and paired with good hoses and correct fluid, this NewYall pump is intended as a long-term replacement for the original equipment unit. Longevity depends on installation quality and maintaining the steering system—leaks, contaminated fluid, or a worn belt will shorten service life.

• Intended to meet or replace OEM fit where specified
• Proper system maintenance extends service life
• Inspect related components to avoid premature pump failure

Who is this for: This NewYall pump is aimed at DIY mechanics, independent repair shops, and owners of the listed Lexus and Toyota V6 vehicles needing a direct-fit power steering pump with an M16 x 1.5 outlet. If your car matches the model and year coverage and you’re replacing a worn or leaking pump, this unit provides a cost-effective aftermarket option—just verify fitment and follow recommended installation and bleeding procedures.