Nirakoka controller-to-motor harness 6-pin 35 ft — direct-replacement for RV in-wall slide-outs, pre-terminated #238992

Nirakoka's 35-foot 6-pin controller-to-motor harness #238992 is a direct-replacement wiring assembly made to reconnect your In-Wall RV slide-out controller to its motor quickly and reliably.

When a slide-out stops responding or the control module and motor lose their connection, a single, correctly wired harness is often the fix. This product is a factory-style male-to-female wiring assembly, 35 feet long and terminated with a 6-pin configuration to match many in-wall RV slide-out systems. It replaces part number 238992 and is intended for use in 5th-wheel trailers, travel trailers, and motorhomes; the motor and controller are not included.

How will this harness fit my RV's slide-out system?

The Nirakoka #238992 harness is engineered as a plug-and-play replacement for many In-Wall slide-out systems that accept a 6-pin controller-to-motor connection. Always verify your OEM part number and connector style before installation. If your owner's manual lists part #238992 or shows a 6-pin male-to-female cable assembly with similar routing, this harness is likely compatible.

• Direct-replacement for part number 238992 in many systems
• 6-pin male-to-female termination matches standard controller/motor ports
• Designed for In-Wall slide-outs used in 5th wheels, travel trailers, and motorhomes
• Confirm fit using your RV owner's manual or OEM part reference

What installation considerations should I know?

Installation is straightforward for anyone comfortable with RV wiring and routing slide-out cables. The assembly arrives pre-terminated, so no splicing or assembly is required; however, you may need basic tools, access panels, and cable clips to secure the run. If the routing path differs from the original, allow extra time to route and fasten the harness to prevent chafing and interference.

• Pre-terminated male-to-female assembly—no cutting or connecting needed
• 35-foot length accommodates extended routing across chassis and slide mechanisms
• Use cable ties and grommets to protect against abrasion and movement
• Power should be disconnected before starting any wiring work

What performance and durability features does this harness offer?

Built to handle the electrical and environmental demands of RV slide-out systems, this harness focuses on secure pin contacts and dependable signal transmission. The 6-pin design supports the required control lines between controller and motor, while the longer length gives flexibility in routing without stretching or tension. It’s supplied as a robust, ready-to-install cable assembly suited for the rolling, vibrating conditions of road travel.

• Secure 6-pin connections for consistent controller-to-motor communication
• 35-foot reach prevents stress from tight cable runs
• Manufactured for RV use—resists vibration and movement typical in travel
• Sold as the harness only; motor and controller are sold separately

How do I confirm compatibility before buying?

Prior to purchase, compare the harness part number and connector type with your RV documentation or the existing cable. Photographs of the current connector, the mating ports, and measurements of the routing path help ensure you order the correct assembly. When in doubt, contact your RV manufacturer or provide clear images to a parts specialist for confirmation.

• Match with OEM part #238992 where listed in manuals or parts diagrams
• Compare connector shapes and pin counts to your current harness
• Measure routing distances to verify 35-foot length is sufficient
• If unsure, consult an RV technician or parts department with photos

Who is this for: The Nirakoka 35-foot 6-pin controller-to-motor harness #238992 is aimed at RV owners, technicians, and parts installers who need a ready-made replacement cable for in-wall slide-out systems. It's ideal for those repairing 5th-wheel trailers, travel trailers, and motorhomes where the original harness has failed or been damaged and a straightforward, OEM-style replacement is required. Purchase only after confirming compatibility with your vehicle's wiring diagrams or owner's manual.