ORCISH 10 Ton Snatch Block — 22,000 lb Winch Recovery Pulley, fits 0–3/4" Rope, Steel, Anti‑Corrosion

ORCISH 10 Ton Snatch Block is a heavy‑duty pully that doubles your winch’s pulling capacity and redirects line safely for complex vehicle recoveries.

Built for off‑road recovery, towing and rigging, this 22,000 lb (10 ton) snatch block accepts 0–3/4" steel cable or synthetic rope and is engineered to reduce winch load and heat while increasing mechanical advantage. Constructed from reinforced steel with anti‑corrosion coating and an upgraded circlip design, it helps prevent unilateral rope jams and extends component life when used correctly. The unit is compatible with trucks, ATVs, UTVs and a wide range of portable winches for on‑trail and field use.

How does this snatch block make winch pulls safer and easier?

By changing the rope’s direction and offering a 2:1 mechanical advantage, the snatch block halves the effective load on the winch and motor, reducing stress and heat. That means longer pulls with less battery drain and reduced gear wear, which is especially valuable during repeated recoveries.

• Doubles pulling power via redirection for more efficient winching
• Lowers winch motor amp draw and gear strain during heavy pulls
• Enables safer alignment around trees and obstacles to reduce side loads
• Durable steel construction resists deformation under rated loads

What rope and vehicle setups does the ORCISH snatch block work with?

The pulley accepts steel cable and modern synthetic recovery rope up to 3/4" diameter, making it suitable for most portable and vehicle‑mounted winches. It’s sized and rated for trucks, SUVs, tractors, ATVs and UTVs involved in off‑road rescue or farm and industrial rigging tasks.

• Compatible with 0–3/4" steel cable or synthetic rope
• 10 ton / 22,000 lb maximum working load capacity
• Fits common winches used on trucks, ATVs, UTVs and utility vehicles
• Useful for both recreational and commercial recovery operations

What safety features and maintenance tips should users follow?

This upgraded model includes a redesigned central circlip to help keep rope seated in the middle and avoid edge‑loading that causes unilateral forces. Inspect the block for deformation before each use, and maintain the pivot and sheave with recommended lubrication to preserve smooth operation and safe service life.

• Check that rope runs through the circlip center to prevent jamming
• Inspect for bends, cracks, or corrosion before every recovery
• Grease pivot and sheave areas as part of routine maintenance
• Replace the block if any structural deformation is found

How much load can it handle and what limitations exist?

The ORCISH snatch block is rated for a 10 ton (22,000 lb) maximum load under correct installation and use with compatible rope. It is not a substitute for a properly sized rigging system and should not be used beyond its rated capacity or with damaged ropes or hardware.

• Working load limit: 10 tons / 22,000 lbs
• Use only with 0–3/4" diameter rope or cable in good condition
• Avoid side loading or shock loads that exceed rating
• Not for lifting personnel; intended for vehicle and equipment recovery

Who is this for: Off‑road drivers, recovery technicians and anyone who relies on winches for vehicle recovery, farming or fieldwork will benefit from the ORCISH 10 Ton Snatch Block. It’s designed for users who need a robust, corrosion‑resistant pulley to increase mechanical advantage, protect their winch system and manage complex angle pulls safely. If you perform frequent recoveries or require an adaptable redirection pulley for heavy loads, this snatch block is a practical addition to your recovery kit.