ORCISH 10 Ton Snatch Block Pulley — 22,000 lb Capacity, Works with 0–3/4” Rope, Heavy-Duty Off-Road Recovery

ORCISH 10 Ton Snatch Block is a heavy-duty pulley that doubles winch pulling power and handles up to 22,000 lbs for safe vehicle recovery.

This snatch block and tackle pulley is built for off-road and utility recovery tasks that require extra mechanical advantage. Constructed from heavy-duty steel with anti-corrosion coatings and upgraded circlip guidance, the ORCISH block accepts 0–3/4” synthetic rope or steel cable and is designed to reduce winch load, gear strain, and battery draw during demanding pulls.

How does this snatch block increase my winch’s pulling power?

By redirecting rope and creating a two-to-one mechanical advantage, the ORCISH snatch block effectively halves the load seen by your winch motor while doubling the effective pulling capacity. That means you can recover heavier loads or reach further without overstressing the winch. The heavy steel sheave and secure hook keep the rope tracking correctly for consistent pulls.

• Doubles winch traction for more effective recoveries
• Compatible with 0–3/4” synthetic rope and steel cable
• Reduces motor heat, gear stress, and battery amp draw
• Upgraded circlip centers prevent unilateral rope jamming

Will this snatch block work with my truck, ATV, or tractor?

The ORCISH block is intended for a wide range of vehicles including trucks, tractors, ATVs, and UTVs. Its 10-ton (22,000 lb) rated capacity and robust construction accommodate typical off-road recovery scenarios. Always inspect fittings, match rope diameter to the sheave, and follow safe rigging practices for your vehicle’s configuration.

• 10-ton rated for heavy-duty offroad use
• Works with most common winches and recovery ropes
• Suitable for navigating obstacles and changing pull directions
• Recommended pre-use inspection and proper rigging

What safety and maintenance steps should I follow?

Regular inspection and simple maintenance extend service life and improve safety. Check the snatch block for deformation, secure circlip alignment, and smooth sheave rotation before each recovery. Lubricate the fitting as needed and replace any damaged parts immediately to avoid failure under load.

• Inspect for deformation or corrosion before use
• Ensure rope sits centered on the upgraded circlip guide
• Use grease fitting for periodic lubrication
• Replace worn components rather than risking continued use

How do I set up the block for a standard two-to-one rig?

Attach the ORCISH snatch block to a secure anchor (tree strap, shackle, or rated anchor point), route the winch rope through the sheave, and connect the rope end to the load or vehicle. Keep rope alignment centered in the circlip and take up slack before applying steady winch power. Monitor the setup during the pull and stop to re-check if anything shifts.

• Secure block to a rated anchor or shackle
• Feed winch rope through sheave and center on circlip
• Connect rope end to the stuck vehicle or load
• Apply steady winch power and observe the system during pull

Who this is for: The ORCISH 10 Ton Snatch Block is suited for off-road enthusiasts, farmers, utility operators, and anyone who routinely recovers vehicles or moves heavy loads with a winch. If you need a durable, heavy-duty pulley to increase pulling power, reduce strain on your winch, and handle a range of rope types, this block is designed for those practical recovery and rigging tasks. Always pair it with appropriate rated hardware, follow safe rigging procedures, and inspect before each use.