Partman Steering Rack Boots 2-Pack – Direct-Fit for Polaris Ranger & RZR 2005–2016, Molded Rubber

Partman steering rack boot 2-pack protects the tie-rod ends and rack assembly on Polaris Ranger and RZR models from 2005–2016, replacing OEM parts 5412012 and 5412013.

If you ride off-road, dust, mud and water can wear out the steering rack boots, causing premature joint and rack damage. These two replacement boots are molded to match the original fit for driver and passenger sides and provide a cost-effective way to restore weather protection to the steering assembly on a wide range of Polaris Ranger and RZR vehicles.

Which Polaris models and years will these boots fit?

These boots are designed as direct-fit replacements for multiple Polaris Ranger and RZR model ranges from 2005 through 2016. They correspond to the driver and passenger part numbers used by Polaris, ensuring the correct geometry and clamp locations.

• Compatible with Polaris Ranger and RZR 400, 500, 570, 700, 800, 900, and 1000 variants.
• Specific year coverage: Ranger/RZR 500 (2006–2012); 570 (2012–2016); 700 (2005–2009).
• Also fits 800 (2008–2014), 900 (2012–2016), 1000 (2014–2016).
• Replaces OEM P/Ns 5412012 (driver) and 5412013 (passenger).

How do these replacement boots protect the steering system?

The boots seal the connection between the steering rack and tie rods, keeping grit, moisture and debris away from moving parts. By maintaining a dust- and water-resistant barrier, the boots help preserve joint lubrication and prolong the life of the rack and tie rods.

• Molded rubber resists tearing and flexes with steering movement.
• Prevents contamination that accelerates wear on rack seals and tie-rod ends.
• Restores OEM-style coverage and clamp points for reliable sealing.
• Sold as a pair so both sides are protected after replacement.

What’s included and how simple is installation?

The package contains two steering rack boots—one for each side—so you can replace both at once. Installation is straightforward for mechanically inclined owners and requires basic tools; clamps or zip-ties are typically used to secure the boots in place.

• Contains 2 x steering rack boots (driver and passenger).
• No additional OEM parts required if clamps are reusable; otherwise use standard steering boot clamps.
• Typical install: remove wheel, unfasten old boot clamps, slide off old boots, fit new boots and secure.
• Helps avoid more extensive steering repairs when replaced proactively.

Are these boots the same shape and size as the original parts?

These boots are manufactured to match the original profile and connection points for the listed Polaris models. They are intended as direct replacements for the OEM numbers cited, ensuring proper fit and steering travel clearance.

• Engineered to match OEM geometry and clamp positions.
• Flexible rubber compound accommodates steering motion without binding.
• Driver side corresponds to P/N 5412012; passenger side to P/N 5412013.
• Sold as a matched pair to maintain balanced protection on both sides.

Who is this for: This 2-pack from Partman is aimed at Polaris owners, mechanics and DIY enthusiasts who ride in dusty, muddy or wet conditions and want to prevent steering wear. If your vehicle shows torn or split rack boots, or you’re performing routine steering maintenance on Ranger/RZR models listed above, these replacement boots provide a practical, OEM-fit solution without needing full steering assembly replacement.