PBYMT 1157 LED Turn Signal Kit 2-inch Smoked Lens for Harley 1986–2024 — 48 SMD LEDs, Plug-and-Play

These PBYMT 1157 LED 2-inch turn signals are a plug-and-play front and rear indicator kit with smoked lenses designed to boost brightness and durability on compatible Harley models from 1986–2024.

Upgrade your Harley's signaling with a compact LED kit built to replace 2-inch 1157/1156 bulb-style turn signals. The set includes two front and two rear LED units plus four smoked PC lens covers, delivering a modern look, higher visibility, and long service life while preserving the classic bullet turn-signal silhouette.

Will these fit my Harley and which models are supported?

These 2-inch PBYMT signals are engineered specifically for many Harley-Davidson motorcycles made between 1986 and 2024. They are compatible with a wide range of Touring, Softail, Sportster and Dyna bikes but do not work with 3-1/4" turn-signal housings or non-Harley brands.

• Touring: Road Glide, Street Glide (excluding CVO/Limited/Classic/Ultra variants)
• Softail: Fat Boy, Fat Bob, Low Rider, Slim, Sport Glide models
• Sportster: 48, 72, 883, 1200 variations including SuperLow
• Dyna: Low Rider, Wide Glide, Fat Bob, Street Bob and similar models

How much brighter and longer-lasting are these LEDs compared with stock bulbs?

PBYMT’s 1157 LED units use 48 high-intensity SMD LEDs delivering roughly four times the brightness of traditional halogen or older 24-LED designs. The circuit and thermal management reduce power draw and stress on components, achieving an estimated lifespan of more than 50,000 hours under normal use.

• 48 SMD LEDs per lamp for improved visibility
• Approximately 400% brighter than standard halogen/older LED alternatives
• Overload protection and ventilation for extended durability
• Rated life exceeding 50,000 hours with low power consumption

Is installation difficult, and will I need extra parts like resistors?

Installation is designed to be quick: the units use an all-in-one plug-and-play wiring approach that most users can fit in about three minutes per light. Some Harley electrical systems may flash at the wrong rate with LEDs; in those cases a load resistor or LED-capable flasher is required to restore normal flash cadence.

• Wireless all-in-one design for fast plug-and-play mounting
• Typical install time: about 3 minutes per signal
• Load resistor may be needed to correct hyper- or slow-flashing
• Not compatible with 3-1/4" flat style turn-signal housings

What do I get in the box and how weatherproof are the parts?

The kit ships with two front LEDs, two rear LEDs and four smoked polycarbonate (PC) lens covers. The smoked lenses are made from IP67-rated material to resist dust and moisture while allowing excellent light transmission so the signals remain visible and protected.

• Included: 2 front LEDs, 2 rear LEDs, 4 smoked lens covers
• Lens material: high-transparency PC with IP67-level protection
• Smoked finish balances stealthy styling with clear output
• Designed specifically for Harley fitments—other brands not supported

Who is this for? If you ride a compatible Harley-Davidson model from 1986–2024 and want a compact, brighter replacement for 2-inch bullet-style turn signals that’s quick to install and built to last, this PBYMT 1157 LED kit is a practical styling and safety upgrade. It’s ideal for riders who prefer a subtle smoked look while improving signal visibility, and for DIYers comfortable adding a resistor if the bike requires it for correct flash rate.