PBYMT 2" LED Turn Signals for Harley 1986-2024, Smoked Lens Pack, 81-LED Front & Rear

PBYMT 2-inch LED turn signals are compact, ultra-bright replacements for compatible Harley-Davidson models that combine 81 SMD LEDs, smoked IP67 lens covers, and plug-and-play wiring for faster, clearer signaling.

Upgrading to high-output LED signals improves visibility and refreshes your bike's look while staying compatible with the classic 2-inch bullet-style sockets found on many Harley-Davidson motorcycles from 1986 through 2024. This set provides front and rear units, four smoked covers for a stealthy finish, and an efficient circuit board designed for long life and stable operation. Installation is straightforward for most riders, though some bikes may need a load resistor to normalize flash rate.

Will these turn signals fit my Harley model?

These lights are built specifically for 2-inch bullet-style housings used on Dyna, Softail, Sportster, Touring, Street Glide, Road King, and Road Glide models between 1986 and 2024. They are not compatible with 3-inch or 3-1/4-inch flat-style turn signal housings.

• Designed for standard 2" bullet-style sockets common on many Harley models.
• Covers a broad model range: Dyna, Softail, Sportster, Touring families and variants.
• Not suitable for larger 3" or 3-1/4" flat-type signals—measure before ordering.

How much brighter and longer-lasting are these LEDs compared to stock bulbs?

Each unit packs 81 SMD LEDs and is engineered to deliver substantially higher lumen output than factory halogen bulbs or lower-count LED alternatives. The internal circuit and heat management are designed for endurance, giving an expected service life measured in tens of thousands of hours.

• 81 high-intensity SMD LEDs for markedly improved visibility.
• Reportedly up to 600% brighter than typical halogen or small-LED setups.
• Durable circuit board and thermal design for approximately 60,000+ hours of use.

Are these waterproof and rugged enough for road use?

The lens covers are made from PC material rated IP67, which keeps dust and water out under normal riding conditions. The smoked covers not only add a low-profile aesthetic but also maintain good light transmission so signals remain noticeable in daylight and wet weather.

• IP67-rated smoked PC lens covers provide dust and water resistance.
• Sturdy construction resists vibration and road exposure.
• Smoked finish balances stealthy appearance with sufficient visibility.

How difficult is installation and will my bike need extra parts?

These signals use an all-in-one plug-and-play wiring approach for quick swaps in many applications—some riders report completing installation in just minutes. Certain motorcycles with hyper-fast LED flash controllers or low-power bulb detection may require a load resistor to achieve a normal flash cadence.

• Plug-and-play design for straightforward replacement of 2" bullet-style signals.
• Typical install time: a few minutes for each side when connectors match.
• Load resistor may be needed to correct hyper-fast flash on some models (not included).

Who is this for: This set is aimed at Harley owners who want a compact, high-visibility LED upgrade that preserves classic bullet-signal mounting. Choose these if you have a compatible 2-inch housing, seek a brighter, longer-lasting signaling solution, and prefer a smoked, low-profile aesthetic. If your bike uses larger flat signals or you want integrated sequential effects, consider alternate products or verify fitment before purchase.