Poli Glow Mitt Applicator for Boats & RVs — Damp Microfiber, Streak-Free Gelcoat Finish

If you want a faster, more controlled way to spread Poli Glow on gelcoat and fiberglass than a small chamois or a bare hand, this microfiber mitt was built for the job. It replaces the older 7" hand-held chamois applicator and gives broader, consistent coverage while keeping the product from puddling. The mitt is intended to be used slightly damp, wiped in straight passes, and rinsed periodically to maintain even application.

How should I prepare the mitt before starting?

Begin by wetting the mitt with fresh water and wringing it until it’s damp but not dripping. Wrap and re-wring with a towel to remove excess moisture; this helps the mitt hold just enough product to spread Poli Glow evenly without streaks or runs. During longer jobs, rinse and repeat the process as needed.

• Dampen with fresh water, wring out until moist
• Wrap in towel and re-wring to remove excess water
• Wear disposable rubber or plastic gloves under the mitt
• Rinse mitt occasionally and re-dampen to maintain performance

What is the recommended application technique for best results?

Pour several lines of Poli Glow onto the palm area of the mitt and apply with straight, even wipes—either top-to-bottom or side-to-side—working a roughly 4' x 6' section at a time. Avoid circular motions; each thin coat dries quickly (typically 1–2 minutes depending on temperature), so plan to apply at least six thin coats before moving to the next area.

• Drizzle product onto the mitt’s palm area for controlled dispensing
• Wipe in straight passes, not circles, across 4' x 6' sections
• Allow approximately 1–2 minutes drying between thin coats
• Apply a minimum of six coats for a durable, even finish

How do I maintain the mitt during and after use?

Keep the mitt damp while working by rinsing and re-wringing when buildup occurs; a clogged mitt will cause uneven coverage. After finishing, rinse thoroughly with fresh water, remove trapped product from the fibers, and allow to dry fully before storage to prolong its life and preserve performance.

• Rinse mitt during use to remove accumulated residue
• Re-wring to restore the damp feel for consistent spreading
• Thoroughly wash and air dry after each job to avoid hardened buildup
• Store dry in a cool place away from direct sunlight

Who is this for? The Poli Glow Mitt Applicator is aimed at boat owners, marina professionals, and RV enthusiasts who want a faster, more uniform way to apply Poli Glow to fiberglass and gelcoat. It’s ideal for anyone replacing a small chamois applicator or seeking improved coverage across larger panels; it reduces finger contact with product and helps produce a smoother, more consistent finish when used as directed.