QHHR Convertible Hydraulic Hose Lines Pair 116-inch with 90° Metal Fittings for Classic American Convertibles

QHHR convertible power-top hydraulic fluid hose lines are a matched pair of 116-inch plastic hoses with 90° metal fittings designed to replace worn or leaking lift system lines on classic American convertibles.

This kit supplies two long, pre-fitted hydraulic fluid lines engineered to connect convertible top pumps to cylinders on a wide range of vintage vehicles. Built to fit many Ford, Mercury, Chevrolet, Oldsmobile, Pontiac, Buick and Plymouth models from the 1960s through early 2000s, the hoses arrive ready to install with 90-degree ends that help route under trim and around structural frames. A one-year warranty backs the set for defects, and the lengths and ends are chosen to simplify replacement without custom flaring or adapters for many common layouts.

Will these hoses fit my classic Mustang or Chevy convertible?

The pair is sized and finished to match the factory routing on many popular convertibles and hard-to-access pump locations. Check the listed model years and compare hose routing lengths to your vehicle before ordering to ensure compatibility.

• Fits many Ford Mustangs (1964–2004) and Mercury Cougar models listed in the compatibility notes.
• Compatible with Chevrolet Chevelle, Caprice, Camaro and other GM convertibles within the given years.
• Includes a wide selection of Mopar and Buick/Pontiac/Oldsmobile vehicles from the 1960s–1970s as specified.
• Both hoses measure 116 inches to accommodate longer factory runs under bodywork.

How are the hose ends and fittings configured?

Each hose in the kit is finished with 90-degree fittings on both ends so the connections clear body panels and brackets without sharp bends that can cause premature wear. The angled fittings reduce stress at the junction points and make routing around the pump and cylinders more straightforward.

• 90° fittings on both ends for improved clearance and reduced kinking risk.
• Pre-attached metal fittings eliminate the need for on-vehicle crimping or custom adapters in most installations.
• Durable plastic hose construction resists common convertible hydraulic fluids used in older systems.

What should I expect during installation and maintenance?

Installation involves removing the old hoses, matching the fittings and routing the new lines along the original path, then bleeding the hydraulic system per the vehicle manufacturer’s procedure. No special tools are usually required beyond standard hand tools and a proper fluid reservoir cap; however, a helper and light are useful for tight spaces.

• Replace one hose at a time to keep pump and cylinder alignment intact during swap.
• Bleed the hydraulic lines after installation to remove air and restore crisp top operation.
• Inspect clips and brackets; reuse or replace mounting hardware to prevent chafing.

Who is this kit for? This QHHR hose pair is aimed at restorers, DIY mechanics and professional shops working on vintage American convertibles that need reliable long-run hydraulic lines with factory-friendly 90° ends. If you own or maintain a classic Ford, GM, Plymouth, Buick or Mercury convertible listed in the compatibility details and want a ready-made replacement to avoid custom hose fabrication, this set offers straightforward fitment and backed support with a one-year warranty.