RANSOTO Can-Am UTV Brake Pad Kit — Front & Rear 8-Pad Set with 8 Retaining Pins (2016–2025) — Full 4-Wheel Replacement

RANSOTO front and rear brake pad kit supplies eight replacement pads plus eight retaining pins engineered to fit select Can-Am Maverick, Commander and Defender UTV models from around 2016–2025.

Designed as a full four-wheel pad swap for compatible Can-Am units, this kit gathers the position-specific front-left, front-right, rear-left and rear-right pads into a single package so you can service both axles at once. It’s intended for owners who verify original pad reference numbers and need a straightforward parts-only replacement—rotors, calipers, springs and fluids are not included. Read the fit notes and installation guidance below to confirm compatibility and prepare for a safe, correct replacement.

Which Can-Am models and years work with this brake pad set?

The kit fits many Can-Am Maverick X3/X3 MAX (2017–2025), Maverick Trail and Sport (2018–2025), Commander and Commander MAX (2021–2025), and a range of Defender models including select Defender MAX, Defender PRO and Defender 6X6 configurations from 2016–2025. Fitment varies by trim and axle setup, so confirm your vehicle’s specific pad numbers before ordering.

• Compatible series: Maverick X3, Maverick Trail, Maverick Sport, Commander, Defender families.
• Model years covered: approximately 2016–2025 depending on configuration.
• Confirm all four OE pad reference numbers for accurate fit.

How do I verify the correct pad references for my UTV?

Check the part numbers stamped on your existing brake pads or consult the vehicle’s parts manual or dealer to match position-specific references. This kit replaces front-left 715900379, front-right 715900380, rear-left 715900386 and rear-right 715900387; some current pads use references 703501198 and 703501199—always confirm each caliper position separately.

• Inspect the pad backing plate or package for the OE number label.
• Compare all four original pad numbers to those listed for this kit.
• If unsure, provide VIN or speak with a dealer for exact match.

What hardware is included and what else will I need?

This set contains eight brake pads and eight silver-tone retaining pins—one pin per pad location—yielding 16 distinct components when counting both pads and pins. Note that some pad pieces include integrated retaining tabs; there are no separate spring clips supplied, nor are fluids, rotors or calipers part of the kit.

• Included: 8 friction pads + 8 retaining pins (front and rear positions).
• Not included: spring clips, brake rotors, calipers, brake fluid, or tools.
• Recommendation: inspect rotors and calipers and follow manufacturer service procedures.

What should I expect during installation and maintenance?

Installation follows standard disc-brake service procedures: lift and secure the vehicle, remove wheels, extract caliper pins and old pads, inspect components, then fit the new pads and retaining pins. Because the friction compound specifics aren’t provided here, break-in behavior can vary—perform a controlled bedding-in and check brake performance before normal use.

• Follow torque specs and hydraulic safety steps in your service manual.
• Replace pads on both sides of an axle to maintain balanced braking.
• Verify caliper operation, rotor condition and brake fluid level after install.

Who is this for: This RANSOTO kit is aimed at Can-Am UTV owners, DIY mechanics and service shops that need a complete front-and-rear pad replacement for compatible Maverick, Commander and Defender machines. It’s best for those who can confirm OE pad numbers and intend to replace worn pads as part of routine brake maintenance or before a demanding riding season. If you require spring clips, caliper parts or detailed friction compound specifications, factor those needs into your purchase plan or consult a dealer before installing.