RecPro RV 20A Tandem Circuit Breaker Q2020 — 120V Camper Replacement, 10,000 AIC

This compact RecPro replacement breaker restores overcurrent protection to your camper’s 120-volt branch circuit using a tandem (twin) single-pole design. Built with a 10,000 AIC interrupting capacity, it fits many RV breaker panels where space is limited and provides the same basic protection and switching as the factory part it replaces. The Q2020 form factor is intended for quick swaps to get lights, outlets, or appliances back online while matching common RV electrical configurations.

Will this breaker fit my RV panel?

Compatibility depends on the panel layout and the original breaker form factor; the RecPro Q2020 matches tandem single-pole slots used in many RVs. Confirm that your panel accepts a twin (tandem) breaker and that the original was rated at 20 amps and 120 volts.

• Tandem single-pole design for two circuits in one slot
• 20 amp rating per pole for typical branch circuits
• Intended for 120-volt RV systems
• Check manufacturer panel chart or existing breaker markings before purchase

How does the 10,000 AIC rating affect safety?

The 10,000 AIC (Ampere Interrupting Capacity) indicates the maximum fault current the breaker can safely interrupt without damage. That rating helps ensure the breaker will clear short-circuits or large faults commonly encountered in RV shore or generator power setups when within its specified limits.

• 10,000 AIC suitable for many RV shore power situations
• Provides reliable interruption for short-circuits up to its rating
• Matches common aftermarket and OEM RV requirements
• Not a substitute for panel-specific higher AIC demands—verify panel specs

How do I install the RecPro Q2020 breaker safely?

Turn off all shore or generator power and remove the panel cover before replacing the breaker. Swap the old tandem breaker for the RecPro Q2020, ensure proper seating on the bus, tighten any terminal screws to manufacturer torque, and restore power for testing.

• Always disconnect external power sources first
• Confirm wiring and polarity match the original breaker connections
• Tighten terminals per panel specifications to avoid loose connections
• Test circuits after installation to verify correct operation

Who is this for: The RecPro RV Circuit Breaker Q2020 is intended for RV owners, DIYers, and service technicians needing a direct replacement for a 20-amp tandem single-pole breaker in 120V camper electrical panels. It’s suited for situations where panel space is limited but two protected circuits are required, and for anyone wanting a straightforward, OEM-form compatible replacement with a 10,000 AIC rating. If you’re unsure about compatibility, consult your RV owner’s manual, the panel labeling, or a qualified electrician before purchasing.