RisWhiteMeteors Power Trim & Tilt Assembly for Mariner/Mercury 40–60HP — Direct OEM Replacement, Corrosion-Resistant

Professionally engineered electrically hydraulic power trim and tilt assembly designed as a direct replacement for Mariner/Mercury 40–60HP outboards (OE 830150T10, 8M0055006, 8M0055011).

This RisWhiteMeteors power trim & tilt unit restores smooth, reliable trim control for compatible Mariner and Mercury 40–60HP outboard motors. Built to meet OEM standards and fully tested before shipment, the assembly offers marine-grade corrosion resistance and stable hydraulic performance so you can quickly replace worn or failed original equipment without extensive modification.

How does this trim & tilt assembly fit my Mariner or Mercury outboard?

It’s manufactured to match OEM mounting points and hydraulic connections for Mariner/Mercury 40–60HP models that use part numbers 830150T10, 8M0055006, or 8M0055011. The unit is a direct physical and functional replacement so no custom brackets or adapters are typically required.

• Direct replacement for OE 830150T10, 8M0055006, 8M0055011
• Designed for Mariner/Mercury 40–60HP outboards
• Standard hydraulic and electrical interfaces for easy swap
• Comes fully assembled and tested, ready to install

What performance and durability features matter on the water?

This assembly uses high-performance hydraulic components to produce smooth lifting and stable operation under load. The casing and fittings are marine-grade and corrosion resistant, engineered to withstand wet environments and repeated trim cycles.

• Hydraulic system tuned for controlled, low-noise actuation
• Corrosion-resistant materials for longer service life
• Stable operation under repeated use and varying loads
• Pre-shipment testing to verify function and integrity

How simple is the installation and what comes in the package?

Installation is straightforward for technicians or experienced DIYers familiar with outboard trim systems; the unit arrives fully assembled and tested. Typical installation involves removing the old assembly, transferring any necessary fittings or harnesses, and bolting the new unit to the transom bracket following manufacturer torque specs.

• 1x power trim & tilt assembly included
• Pre-tested and ready to mount—no reassembly required
• Compatible with original mounting points and hose/cable routings
• Follow boat and outboard service manual for electrical hookup and bleeding procedures

What should I check after fitting the replacement unit?

After installation, verify correct electrical supply, confirm there are no hydraulic leaks, and exercise the trim through its full travel to purge air and ensure smooth movement. Also recheck fastener torque and secure hose clamps after the first outings.

• Confirm correct voltage and secure electrical connectors
• Inspect for hydraulic leaks and tighten fittings if needed
• Cycle trim to remove trapped air and verify smooth motion
• Re-inspect fasteners and fittings after initial use

This RisWhiteMeteors electrically hydraulic power trim & tilt assembly is intended for boat owners, marine technicians, and service shops that need a reliable, OEM-compatible replacement for Mariner and Mercury 40–60HP outboards. Choose this unit if you require an assembly that meets OEM part compatibility, arrives fully tested, and is built with marine-grade materials to reduce downtime and extend on-water service life.