RUPES 150mm White D-A Ultra-Fine Polishing Foam Pads (Pack of 2) — 5" Backing Plate Compatible, Finishing Gloss & Low-Swirl

RUPES 150mm White D-A Ultra-FINE Polishing Foam Pads are precision foam discs designed for the final refining and ultra-fine polishing step on dual-action polishers to boost gloss while minimizing swirl marks.

These 150mm (approximately 6") white ultra-fine foam pads from RUPES are built specifically for dual-action (D-A) polishers and pair with 5" backing plates. They are intended for the last stages of paint correction where refining clarity and surface uniformity matter most. Constructed from open-cell foam, the pads balance product distribution and heat dissipation to reduce clogging and prevent pad breakdown during repeated use.

How do these pads improve final gloss and clarity?

The white ultra-fine foam has a softer, low-friction structure that helps lift micro-marring left by more aggressive stages without reintroducing new swirls. When matched with a light compound or finishing polish, it refines the paint surface to reveal depth and enhance reflectivity.

• Ultra-fine cell structure reduces micro-marring and hazing
• Optimized for finishing polishes and glazes to maximize shine
• Open-cell design promotes even product spread for consistent results

Will these pads fit my machine and how are they best used?

Each pad is sized to work with 150mm (approx. 6") surfaces and is compatible with common 5" hook-and-loop backing plates used on D-A polishers. Use moderate speed and light pressure for finishing passes, and allow the pad to float across panel curves to avoid heat buildup.

• Designed for dual-action polishers and 5" backing plates
• Recommended light to moderate pressure and lower speeds for finishing
• Use short, overlapping passes for uniform refinement

How do I clean and maintain these foam polishing pads?

Cleaning is straightforward: rinse with warm water and a mild soap or pad-cleaning solution immediately after use to flush out compounds and polish residues. Squeeze water through the foam without twisting, then air-dry foam-side down to keep the pad shape and extend its usable life.

• Rinse under warm water with gentle soap to remove residues
• Avoid machine wringing; hand-squeeze and air dry foam-side down
• Inspect for tears or compressed areas; replace when shape is compromised

What kinds of surfaces and corrections are these pads suitable for?

These pads are intended for extremely fine correction, refining and final polishing on automotive paint, clear coats and other polished surfaces. They work well after compounding stages to remove light defects and boost gloss, and they adapt to a range of finishing products.

• Ideal for final polishing on clear coats and painted surfaces
• Suited for finishing polishes, glazes and light defect removal
• Compatible with many polishing products; always test on a small area first

Who is this for: The RUPES 150mm White D-A Ultra-FINE pads (pack of 2) are for professional detailers and serious enthusiasts who need consistent, high-gloss finishing performance from a dual-action setup. If you perform final-stage polishing, work with delicate paint finishes, or want pads that resist clogging and retain shape through repeated uses, these pads offer a dependable option. They pair especially well with finishing polishes and are a practical addition to a multi-step paint correction workflow.