Suspa 16" Gas Lift Supports (C16-09209) — Pair, 38 lb Each (76 lb Set) for Camper Rear Window & Tonneau Covers, 10mm Ball Sockets

Suspa C16-09209 gas props are a pair of 16-inch, gas-charged lift supports rated at 38 lb each (76 lb per set) designed as OEM-style replacements for camper rear windows, tonneau covers and similar lift applications.

These Suspa lift supports use compressed gas inside a sealed cylinder to provide controlled opening and holding force for panels and windows. Manufactured to match OEM dimensions and fittings, the C16-09209 set is supplied with nylon 10mm ball-socket end fittings and is tested to meet the original specification. The props ship as a matched pair to ensure balanced lift and reliable operation for applications requiring a combined force near 76 pounds.

What measurements and fittings define the C16-09209?

The C16-09209 is a 16-inch nominal gas prop with precise center-to-center lengths and common OEM-style end fittings. Confirm these dimensions and fittings against your original part to ensure fitment.

• Compressed (center-to-center): 9.4 in (239 mm)
• Extended (center-to-center): 15.7 in (399 mm)
• Force per prop: 38 lb (169 N); total for pair: 76 lb
• End fittings: 10 mm nylon ball sockets for quick socket mounting

How do these props perform compared with originals?

Each Suspa lift support is built to meet OEM specifications and undergoes testing to confirm performance close to or exceeding the original unit. Gas-charged supports can slowly lose pressure over time, so new components typically perform stronger than aged originals.

• Tested to OEM dimensions and force output
• Designed to replace specific part numbers rather than serve as universals
• Delivered as a matched two-piece set to maintain balanced lift
• Made in the USA, with quality control per Suspa standards

What should I check before ordering a replacement set?

Verify your existing part number and compare center-to-center lengths and end fitting type before purchase. If the existing part number does not exactly match, internal components or fitment details may differ.

• Confirm original part number equals C16-09209 / C1609209
• Measure compressed and extended center-to-center distances
• Check that your mounting uses 10 mm ball studs compatible with nylon ball sockets
• Replace both supports in a pair to avoid uneven wear and imbalance

How do I mount and maintain these gas supports?

Installation is usually straightforward with ball-socket fittings; press onto the 10 mm studs until fully seated. Maintain by keeping pivots clean and avoiding exposure to corrosive chemicals; gas supports are sealed units and should not be disassembled or punctured.

• Snap onto 10 mm ball studs; no special tools in most cases
• Lubricate mounting studs sparingly with appropriate grease if binding occurs
• Avoid heat sources and sharp impacts that could damage the cylinder
• Replace when noticeable sagging or loss of lift appears

Who is this for? The Suspa C16-09209 pair is intended for vehicle owners, mechanics, and RV/camper DIYers who need OEM-style gas lift supports for rear windows, tonneau covers, or similar panels requiring approximately 76 pounds of combined lift. Choose this set when your original parts match the listed dimensions and fittings and you want a direct-fit replacement made to Suspa’s manufacturing standards.