Tohatsu Canister Oil Filter for 4-Stroke Outboards 9.9–60 HP — OEM 3R0076150M, Lightweight Canister

This oil filter is built specifically to match Tohatsu’s service specifications for their 4-stroke outboard motors. As an original-equipment-number part (3R0076150M), it provides the correct fit, sealing and filtration media designed to work with Tohatsu oil passages and mounting interfaces. Lightweight at about 1 lb, the canister format simplifies installation and routine maintenance aboard recreational and workboats.

How does this filter support routine outboard maintenance?

Using the OEM canister filter keeps your maintenance intervals straightforward and helps ensure the lubrication system runs as the manufacturer intended. Replacing the filter each service cycle reduces the chance of contaminants circulating in critical engine bearings and hydraulic components.

• OEM part number 3R0076150M for direct replacement and reliable fit.
• Canister design allows quick swap during scheduled oil changes.
• Engineered filtration media traps particulates typical in marine use.
• Lightweight construction (approx. 1 lb) for easy handling on deck.

Which Tohatsu models and horsepower ranges does it fit?

This canister oil filter is compatible with a wide span of Tohatsu 4-stroke outboards, covering small tiller models up to mid-range horsepower engines. Verify compatibility against your engine’s parts diagram or service manual before purchasing.

• Fits Tohatsu 4-stroke outboards rated from 9.9 HP through 60 HP.
• Designed for engines that use canister-style oil filters as original equipment.
• OEM specification ensures correct thread, gasket sealing, and height.

What should I expect during installation and replacement?

Installation follows the same steps as other canister-style spin-on filters: drain oil if required, remove the old canister, prepare the sealing surfaces, and torque to the manufacturer’s recommendation. Simple hand tools are typically sufficient, and there’s no special training needed for basic replacement tasks.

• Hand-tighten then follow torque or turn-after-contact per service manual.
• Replace filter each oil service interval or sooner if contaminated fluid is found.
• Check gasket seating and apply a light oil film to gasket for easier sealing.

How can I be sure this is the right part for my boat before ordering?

Confirm the OEM part number and cross-reference with your engine’s model-year parts list to ensure compatibility. If unsure, compare the existing canister’s dimensions, thread pattern and gasket position against the replacement to avoid fitment issues.

• OEM part number: 3R0076150M—match this with your parts manual.
• Compare physical dimensions and thread type to the installed filter.
• Consult Tohatsu dealer or service center for model-specific guidance.

Who is this for: Boat owners, fleet managers and marine technicians who operate or service Tohatsu 4-stroke outboards and want an OEM-grade canister oil filter for dependable fit and straightforward maintenance. Ideal for routine oil-change service on recreational boats, tenders, and light commercial craft using Tohatsu engines in the 9.9–60 HP range.