TORCH Off Road Toyota Tacoma Rear Add-A-Leaf Lift Kit 1.5-2" Rear Lift, Includes Pins & Isolators

This compact rear lift solution is engineered specifically for Tacoma models (1995–2023, 2WD and 4WD, TRD and SR5 variants). The kit supplies two add-a-leaf plates, extended alignment pins, and isolator pads so you can install a rear lift without replacing the entire spring pack. Designed for DIY installers and professional shops alike, the kit keeps installation straightforward while retaining the stock leaf springs' progressive feel.

How much ride height will I actually gain with this kit?

Expect approximately 1.5" to 2" of rear lift once the add-a-leaf is installed; exact results depend on the existing leaf pack condition and truck load. Older, sagging spring packs typically yield closer to the upper end, while nearly-new packs may sit near the lower end of that range.

• Typical lift: 1.5"–2" measured at the rear axle
• Variation depends on leaf wear and existing pack compression
• Leaves included are 2/5" thick — check thread length on factory U-bolts

What hardware and components come in the kit?

The TORCH kit includes two add-a-leaf plates, extended alignment pins for proper centering, and isolator pads to reduce noise and protect spring surfaces. Everything you need for the bolt-on installation is packed in, plus clear step-by-step instructions aimed at the backyard mechanic.

• 2 add-a-leaf plates (2/5" thickness)
• Extended alignment pins for accurate spring alignment
• Isolator pads to minimize friction and rattle
• Printed installation guide for DIY or shop installation

Will I need to change other components or make alignment adjustments?

The add-a-leaf is a rear-only solution and bolts onto your existing leaf pack, so most owners can install without swapping additional suspension parts. However, you should ensure at least 1/2" of thread remains on your factory U-bolts before installation; an alignment check after installation is recommended for optimal handling.

• Check U-bolt thread length — minimum 1/2" required
• Post-install wheel alignment recommended for best tracking
• Not a full spring replacement — retains factory spring characteristics

How durable is the kit and what warranty applies?

TORCH Off Road backs this product with a lifetime warranty and dedicated customer service, reflecting confidence in material and manufacturing quality. The add-a-leaf plates are built to withstand typical street, light-offroad, and payload use when installed per instructions.

• Lifetime warranty included
• Customer service support from TORCH Off Road
• Designed for regular driving and moderate load/terrain demands

Who is this for: The TORCH 1.5"–2" Rear Add-A-Leaf kit is ideal for Toyota Tacoma owners (1995–2023) who want a cost-effective rear lift to level their truck, increase rear load support, or improve clearance without the expense of full spring replacement. It's aimed at DIY mechanics who prefer a bolt-on install as well as installers in independent shops seeking a straightforward, warranty-backed solution.