Traberm 4-Inch Round LED Trailer Tail Lights, Red 6-Pack — 24-LED IP67 Waterproof Flush-Mount

These are six 4-inch round red LED trailer tail lights from Traberm: flush-mount, 24-LED chips each, IP67 water-resistant, with rubber grommets and 3-prong pigtails for 12V vehicle systems.

Replace incandescent bulbs or upgrade faded lenses with this full set designed for trailers, trucks, RVs and utility vehicles. Each lamp uses a cluster of 24 LEDs to provide bright stop, turn and running illumination while drawing minimal current. The kit includes rubber grommets and three-prong wire pigtails so you can complete a clean, flush installation without extra parts.

How do these lights install on my trailer?

Installation is straightforward: the lights are made for flush mounting into a prepared hole and seat into a rubber grommet that seals the fixture. The lights accept a standard three-pin wiring configuration so they connect directly to common trailer wiring harnesses.

• Drill a 4.6" diameter hole for a recessed fit or 5.4" for surface mount depth.
• Grommet ring outer diameter: 5.3"; inner lamp diameter: 4"; housing depth ~1".
• Wire color code: white = ground, red = stop/turn (bright), black = tail/run (dim).
• No screws required when using the rubber grommet for a secure, vibration-resistant fit.

What electrical and performance features should I expect?

Each lamp runs on 12–16 V DC and contains 24 high-efficiency LED chips that produce strong light with low power consumption. The LED cluster offers clearer visibility than traditional bulbs and resists failure from vibration and shock commonly encountered on trailers.

• Designed for 12V systems; compatible across 8–16V DC applications.
• Separate circuits for bright stop/turn and dim tail functions.
• Lower current draw compared with incandescent lamps for less strain on wiring.
• IP67-rated sealing for reliable performance in wet conditions.

Will these lights fit my vehicle and wiring harness?

These round LEDs suit a wide range of trucks, trailers and utility vehicles and use the common three-prong connection found on most trailer wiring. Confirm your available mounting hole size and the three-wire harness compatibility before ordering for a smooth swap.

• Works with semi trailers, utility trailers, RVs, pickups, horse trailers, boat trailers, UTVs and more.
• Fits into a 4" inner diameter lamp opening; recommend ~4.6" drill hole for recessed fit.
• Compatible with standard three-pin plug wiring (connector not included in package).
• Kit includes grommets and pigtails to simplify connection and sealing.

How durable are these tail lights in outdoor conditions?

Constructed to withstand road and weather exposure, the lamps feature an IP67 waterproof rating and solid-state LED construction that tolerates vibration. The rubber grommet further protects the junction from moisture and road spray.

• IP67 protection against dust and immersion up to limited depths.
• LEDs are resistant to vibration and shock encountered on highways and off-road routes.
• Rubber grommet provides a tight seal and helps prevent water intrusion at the mounting point.
• Backed by a two-year support policy for replacements or troubleshooting.

Who is this for? If you maintain trailers, service vehicles, or fleet units and need a reliable, energy-efficient lighting upgrade or replacement set, this six-pack from Traberm is built for easy installation, long outdoor life, and clear stop/turn/running visibility. Choose this kit if you want a full set of matching flush-mount red tail lights with grommets and pigtails included to restore or modernize your vehicle’s rear signaling.