TUSK 2" Pivoting Bar Risers for 1-1/8" Handlebars — 2" Lift, Adjustable Forward/Back Tilt, Black

The Tusk 2" Pivoting Bar Risers are an adjustable, 2-inch handlebar lift that moves your 1-1/8" bars forward or backward for improved comfort and better control on motorcycles, dirt bikes, and ATVs.

If your current riding position causes wrist ache, back strain, or you want a quick way to fine-tune reach and leverage, these pivoting risers let you change bar position without cutting lines or buying new bars. Built to use your existing 1-1/8" clamps, the Tusk risers accept standard 1-1/8" handlebars and provide a compact, reversible solution for riders who need more ergonomic placement or increased leverage on technical terrain.

How do these risers change my riding position?

Pivoting risers raise the handlebars by 2 inches while also allowing forward and backward rotation at the clamp point. That means you can move the grips closer or farther from you and alter the sweep angle, producing a more upright posture or a lower, aggressive stance depending on setup.

• 2" vertical rise to increase cockpit height
• Adjustable pivot to shift bars forward or back
• Works with 1-1/8" handlebars—no new bars required
• Reversible positioning for quick tuning

Will these fit my bike and existing controls?

Tusk risers are designed to fit machines with 1-1/8" (28mm) bar diameter at the clamp. They mount into your factory bar clamps and keep most controls unchanged, but you must confirm there's enough cable and hose slack to accommodate the 2" lift and the pivot travel.

• Fits any 1-1/8" bar clamp standard
• Uses existing clamp mounting points for easy installation
• Check throttle, clutch, brake lines for sufficient slack
• Handlebars are not included—retain your current bars

What performance or comfort benefits can I expect?

Raising and shifting the bar position improves leverage for turning and reduces back and wrist strain on longer rides by promoting a more neutral posture. The pivot feature helps you dial in a hand position that matches your riding style—upright touring, technical trail work, or mixed-terrain adventure.

• Better control and turning leverage in technical sections
• Reduced rider fatigue on extended rides
• Customizable sweep and reach for individual fit
• Pairs well with larger bars and handguards for protection

How difficult is installation and what should I prepare?

Installation is straightforward for riders with basic mechanical skills: remove the stock clamps, fit the risers into the clamp area, position the bars, and tighten to spec. Allow time to route cables and test full steering lock to ensure no binding or excessive tension.

• Compatible with factory clamp hardware—no special tools beyond common shop tools
• Inspect and adjust cable and hose routing after raising bars
• Torque fasteners to manufacturer recommendations
• Test steering range and controls before riding

Who is this for? The Tusk 2" Pivoting Bar Risers suit riders who need a quick, reversible handlebar height and reach change without replacing bars—commuters, adventure riders, dual-sport and off-road enthusiasts who want more comfort, better leverage, or a custom cockpit layout. They are ideal for any machine using 1-1/8" handlebars where there is adequate mounting space and cable slack. Consider pairing these risers with wider or stiffer bars and compatible handguards for a complete control upgrade.