UANOFCN Water Pump Impeller Kit for Honda BF75 BF90 BF115 BF130 — Neoprene & Gasket, Direct-Fit

UanofCn 06192ZW1000 is a complete water pump impeller service kit engineered to rebuild the cooling pump on compatible Honda BF75, BF90, BF115 and BF130 outboard engines.

This service kit contains a neoprene rubber impeller and a non-asbestos gasket designed as a direct-fit replacement for OEM part 06192-ZW1-000. It’s intended for routine water-pump maintenance or emergency repairs on specific Honda Marine four-stroke outboards (models and serials listed below). Replacing a worn impeller helps restore coolant circulation through the engine’s heat-exchange system and prevents overheating caused by reduced water flow.

Which Honda outboards will this impeller kit fit?

This kit fits a range of Honda BF75 and BF90 models from 1999–2006 with certain frame serial limitations, plus all years of BF115A and BF130A models. Always verify your engine model code and serial number before ordering to ensure compatibility.

• BF75AX / BF75AY / BF75A1–A6 series (1999–2006) and BF75DK0, BF75DK2 with frame s/n BBAJ-1200000 and below
• BF90AX / BF90AY / BF90A1–A6 series (1999–2006) and BF90DK0, BF90DK2 with frame s/n BBCJ-1300000 and below
• All-year BF115A and BF130A models
• OEM reference: 06192-ZW1-000 (cross-ref Sierra 18-3283)

How do I know when to replace the impeller?

Replace the impeller if you notice reduced waterflow from the telltale, overheating, or if the impeller shows visible wear when inspected. Routine replacement is recommended as part of scheduled outboard maintenance since rubber impellers dry, crack, or lose shape over time.

• Indicators: weak telltale stream, engine temperature rise, or internal debris
• Visual signs: cracked, torn, or compressed impeller vanes
• Maintenance tip: inspect annually or every 100 hours, whichever comes first

What comes in the UanofCn impeller service kit and what materials are used?

The kit includes a neoprene rubber impeller plus a non-asbestos gasket sized for a direct replacement installation. The materials are chosen to balance durability, flexibility, and resistance to typical marine conditions.

• Neoprene rubber impeller designed for repeated flexing and water sealing
• Non-asbestos gasket to ensure a tight, heat-resistant seal during installation
• OEM cross-reference 06192-ZW1-000 ensures fit and form for specified Honda engines

How should I prepare for installation and what should I check afterward?

Before installing, confirm the engine model and serial number and have basic tools ready to remove the water-pump housing. After installation, run the engine and observe the telltale stream and engine temperature to confirm restored flow and correct seating of the gasket and impeller.

• Preparation: disconnect battery, remove lower unit per manufacturer instructions
• Installation checks: inspect keyways, shaft, and pump housing for wear or corrosion
• Post-install: verify steady telltale flow and normal operating temperature

Who is this for: This UanofCn impeller service kit is aimed at boat owners, marine technicians, and DIY mechanics who operate Honda BF75, BF90, BF115 or BF130 outboards and need a reliable, OEM-referenced replacement part for routine cooling-pump maintenance or repairs. It’s ideal for those who want a direct-fit component that matches Honda part 06192-ZW1-000 and prefer to confirm compatibility using their engine’s model code and serial number before purchase.