UCCKEYI -3 AN 12in Stainless Braided TFE Brake Lines, 2pc Pack, Straight to 90° Fittings

UCCKEYI 2pcs -3 AN 12" stainless braided TFE brake lines are flexible, corrosion-resistant hoses with a straight fitting on one end and a 90° -3 AN fitting on the other for tight or angled brake plumbing.

These preassembled brake hoses combine a PTFE inner liner with a stainless-steel braided jacket and -3 AN fittings to give a compact, durable connection for performance cars, motorcycles, or custom brake setups. At 12 inches measured from flare seat to flare seat, the pair is sized for short runs and hard-to-reach placements where a 90° termination avoids kinking or clearance issues. Each package contains two finished hoses ready for installation, eliminating the need to cut, flare or swage hose ends yourself.

How do these brake lines improve routing in tight spaces?

The built-in 90° -3 AN fitting on one end allows the hose to exit at a right angle, which simplifies routing around suspension components, frames, or bodywork. This reduces stress points and helps maintain a smooth hose curve for consistent fluid flow.

• 90° fitting on one end for compact terminations
• Straight -3 AN fitting on the opposite end for standard connections
• 12" length ideal for short runs and constrained areas
• Preassembled to save cutting and finishing time

What materials and construction are used for durability?

These hoses use a PTFE (TFE) inner liner for chemical compatibility with brake fluids and a stainless-steel braided outer layer that resists abrasion and corrosion. The combination maintains flexible performance while protecting the hose from chafing and environmental exposure.

• PTFE inner tube for fluid compatibility and low permeability
• Stainless-steel braid provides mechanical strength and abrasion resistance
• Metal AN fittings ensure secure, leak-resistant connections
• Uncoated braid for a clean, mechanical appearance and heat tolerance

Are these hoses ready to install or do they need modification?

Each hose arrives fully assembled and measured from flare seat to flare seat, so they are ready for direct installation onto compatible -3 AN ports. No cutting, flaring, or crimping is required unless you need a custom length or different end orientation.

• Sold as a pair (2pcs) — convenient for axle or dual-circuit changes
• 12" measured length reduces guesswork during fitting
• Direct-fit -3 AN threads match standard AN hardware
• Ideal when swapping hoses without altering factory fittings

How should I choose the right hose for my vehicle or project?

Check the thread size (-3 AN) and the required hose routing length before ordering. These hoses are best for short brake runs or aftermarket projects that can accept AN-style fittings and a 12" center-to-center measurement.

• Confirm your caliper, master cylinder, or adapter uses -3 AN ports
• Measure required length from flare seat to flare seat for fitment
• Use the 90° end where clearance is limited or to avoid tight bends
• Buy a pair when replacing both sides of an axle for matched performance

Who is this for: These UCCKEYI braided TFE hoses suit hobbyists, performance tuners, and custom fabricators who need a short, durable brake hose with an angled end for neat routing. They work well on race cars, track bikes, kit cars, and custom brake kits where AN fittings are used. If you require a different length, coating, or fitting angle, consider hose variants or custom assemblies; otherwise this ready-to-install two-pack offers a fast, cost-effective upgrade or replacement for tight-fitting brake plumbing.