Vepagoo 20" Gas Strut Pair 35 lb (156–158 N) — 20in/12.13in Stroke with L-Brackets & Ball-Ends

Vepagoo 20-inch gas strut pair with 35 lb (≈156 N) lift force — engineered to lift and hold medium-heavy lids such as RV beds, trailer doors, and storage compartments with smooth, controlled motion.

These gas springs are a purpose-built replacement or upgrade option when standard struts can’t manage heavier lids. Each kit includes two 20.00" extended (12.13" compressed) struts rated at roughly 35 lb/158 N, plus four adjustable L-type brackets and M8 nuts so you can mount them across a wide range of applications. The design emphasizes practical fit, reliable force, and a straightforward installation experience without specialized tools.

How do these gas struts perform on heavy RV or trailer lids?

They provide controlled opening and holding of lids in the 28–38 lb range, reducing the effort needed to lift and keeping the lid stable when open. The gas charge delivers steady force throughout the stroke for predictable motion and less shock at end positions.

• Rated force: ~35 lb (≈158 N) per strut for medium-heavy lids.
• Extended length: 20.00" (508 mm); compressed: 12.13" (308 mm).
• Best for lids roughly 28–38 lb; use two struts for balanced operation.
• Smooth damping reduces slamming and abrupt movements.

What makes the L-type bracket and ball-end fittings useful for real installations?

The included L-type brackets and rotating ball ends offer extra alignment flexibility so you can mount the struts where straight-line mounts aren’t possible. This makes the kit adaptable to curved hinge lines, offset mounting points, and retrofit scenarios where factory brackets don’t match.

• Adjustable L-brackets to change mounting angle and offset.
• Ball-end connectors rotate to prevent binding during stroke.
• M8 nuts supplied to secure the brackets; screws are not included.
• Bracket geometry helps accommodate uncommon hinge placements.

How simple is installation and what hardware is included?

The kit comes nearly ready to install: two gas struts, four heavy-duty brackets, four M8 nuts, and clear guidance steps. No specialty tools are required for typical installs, though you’ll need appropriate screws or bolts for your mounting surface and a wrench for the M8 nuts.

• Included: 2 struts, 4 L-brackets, 4 M8 nuts, installation instructions.
• Not included: mounting screws/bolts—select appropriate fasteners for your material.
• Installation typically requires basic hand tools and a helper for positioning.
• Designed for a one-time secure install and long service life.

Will these gas springs fit my vehicle or storage application?

They are intended for lids and panels that match the specified stroke lengths and lift capacity; verify your lid weight and available mounting geometry before ordering. If your lid is significantly heavier or much lighter than the recommended range, choose a strut with appropriate force to avoid poor performance or premature wear.

• Measure available extended/compressed length and compare to 20.00"/12.13" specs.
• Confirm your lid weight falls close to 28–38 lb per pair recommendation.
• Check for sufficient clearance for the L-brackets and ball ends to operate freely.
• Contact support if unsure about sizing or fit—Vepagoo offers installation help.

Who this is for: This Vepagoo 20-inch, 35 lb gas strut kit suits DIYers, RV owners, trailer builders, and anyone upgrading storage lids, camper beds, or access panels that need dependable lift assistance. It’s especially helpful when original struts are undersized or mounting geometry requires adaptable brackets. Choose this kit when you want a ready-to-fit pair with clear specs, rotating ball joints, and the flexibility to adapt to nonstandard hinge placements.