Wodvyss 2" 9-LED Round Trailer Side Marker Lights — 10-Pack (5 Amber/5 Red), IP67 Sealed Flush-Mount

Wodvyss 2" 9-LED round marker lights are compact, DOT-approved, sealed clearance and side marker lamps (5 amber, 5 red) built for 12V trucks, trailers, RVs and campers.

These ten compact, sealed LED markers pair high-visibility output with an ultra-slim 2-inch profile for flush mounting in standard grommets. Each lamp contains nine bright LEDs behind a multi-faceted reflex lens, delivering broad, conspicuous light for side and clearance applications while resisting water and road grime thanks to an IP67 rating. The set includes five amber and five red lights, grommets and two-prong pigtails for straightforward replacement of incandescent markers.

How bright are these 2" lights compared with traditional incandescent markers?

Each Wodvyss marker uses nine high-efficiency LEDs and internal micro-reflex facets to increase perceived brightness and spread. You’ll notice faster illumination and a sharper, more consistent signal than old bulbs, which improves visibility at distance and in low-light conditions.

• 9 ultra-bright LEDs per lamp for enhanced outward visibility.
• Faceted reflex lens multiplies light dispersion for a wider viewing angle.
• Quicker on/off response than incandescent bulbs for clearer signaling.

What does "sealed" and IP67 mean for everyday use?

IP67 sealing indicates these markers are protected from dust and can withstand short-term immersion in water up to one meter, so they stand up to rain, road spray, and routine washdowns. The sealed housing also helps prevent corrosion and electrical failures common with open-bulb fixtures, making them more durable on long-haul and off-road vehicles.

• IP67 rating: dust-tight and water-resistant to brief submersion.
• Sealed construction reduces corrosion risk and extends service life.
• Reliable performance in wet, muddy, or salty environments.

Are these lights easy to install and wire on trailers or RVs?

Yes. The kit arrives with rubber grommets and 2-prong pigtails that match common 2-prong trailer sockets. Installation is push-fit: insert the grommet into a roughly 2-5/16" hole, press the lamp into the grommet, and connect the black (positive) and white (ground) leads. No screws are required, though warming the grommet with hot air can simplify insertion in cold conditions.

• Outer diameter with grommet: 2.5"; light-only inner diameter: 2".
• Requires ~2-5/16" hole for grommet seating; push-fit mounting.
• Pre-attached 2-prong pigtails: black = positive, white = ground.

Where on my vehicle can I use these markers?

These compact markers serve as side marker lights or clearance lights wherever a 2" round fixture is appropriate. They’re commonly used on trailers, tractor units, bumpers, sleeper and cab kits, air-cleaner bars, and rear center panels — essentially any 12V vehicle location that requires DOT-compliant side or clearance lighting.

• Suitable for trucks, trailers, RVs, campers and 12V work vehicles.
• Common installations: bumpers, side panels, light bars, rear centers.
• DOT-approved for legal use as side or clearance markers when mounted correctly.

Who is this for: This 10-pack from Wodvyss is aimed at fleet operators, RV owners and DIY trailer technicians who need compact, dependable marker lights for multiple mounting points. It’s a practical replacement kit for anyone upgrading incandescent markers to LEDs, or equipping trailers and campers with sealed, maintenance‑resistant side and clearance lighting that meets DOT expectations.