xcarpad Auto Start-Stop Eliminator — Jeep Wrangler JL/JLU & Gladiator JT 2018–2026, Plug‑and‑Play

This compact plug-and-play module is built for Jeep Wrangler JL and JLU (2018–2026) and Gladiator JT (2020–2026) models (excludes 4XE). It installs at the ECU connector under the driver’s seat and prevents the factory start-stop system from reactivating, while preserving all other factory functions such as remote start and dashboard controls. The unit creates no fault codes when connected correctly and restores normal operation instantly if you press the vehicle’s start-stop button.

How does this eliminate the start-stop feature without affecting other systems?

The xcarpad module intercepts the signal between the vehicle ECU and the start-stop system so the “A‑OFF” state is maintained by default. It is engineered to integrate with the factory wiring harness and avoid triggering diagnostic trouble codes. Because it only modifies the start-stop signal, systems like remote start, drive modes and traction control remain untouched.

• Direct plug-in to the ECU connector under the driver’s seat
• No error codes when connected correctly
• Preserves remote start and other factory features
• Instant re-enable by pressing the dashboard start-stop button

Is installation complicated for an average Jeep owner?

Installation is straightforward and requires no cutting or splicing of wires: unplug the ECU harness and connect the two supplied plugs as illustrated. The procedure takes minutes for anyone comfortable working around the driver’s seat and does not require specialized tools. After installation the start-stop button will switch to the red (A‑OFF) lamp within a few seconds when you start the vehicle.

• Follow the included wiring illustration for correct connector orientation
• No permanent vehicle modifications or soldering needed
• Start the vehicle to confirm the button turns red in 3–5 seconds
• Keep the module accessible for quick removal if desired

Which Jeep models and years are compatible?

This module is specifically designed for Jeep Wrangler JL and JLU models from 2018 through 2026, and Jeep Gladiator JT models from 2020 through 2026. It is not compatible with 4XE hybrid models or other Jeep model lines. Before purchasing, verify your vehicle has a manual Auto Start-Stop (A‑OFF) button on the dash.

• Compatible: Wrangler JL/JLU (2018–2026) and Gladiator JT (2020–2026)
• Not compatible: Jeep 4XE models and other non-listed Jeeps
• Require: vehicle equipped with an A‑OFF dashboard button
• Double-check: correct two-connector orientation during install

Will this affect safety or cause stalls in traffic?

The xcarpad eliminator only prevents automatic engine restarts; it does not change transmission logic, idle control, or vehicle safety systems. Users will not experience unexpected stalling or altered low-speed behavior due to this module. If you ever want the factory start-stop back, a simple press of the A‑OFF button returns normal operation.

• No change to transmission, traction control, or braking systems
• No sudden engine stops or stalls in stop-and-go traffic
• Reversible at any time via the factory button
• Manufacturer support and one-year warranty included

Who is this for: The xcarpad Auto Start Stop Eliminator is aimed at Jeep owners who prefer a consistent A‑OFF setting to avoid frequent automatic restarts—especially drivers in heavy urban traffic or those who find the system intrusive. It suits owners with compatible Wrangler JL/JLU or Gladiator JT models who want a clean, reversible, no‑code solution that installs quickly without vehicle modifications. If you need guaranteed compatibility, confirm your vehicle year, model, and presence of the A‑OFF button before ordering.