XINRINTONG Cruise Control Cutout Brake Switch Repair Kit for Ford 1992-2008 — Direct-Fit SW6350, Restores Cruise Response

XINRINTONG Cruise Control Cutout Brake Switch Repair Kit replaces a faulty brake switch sensor to restore cruise control response and stop false cutouts in compatible Ford, Mercury, and Lincoln models.

This repair kit is a direct-fit replacement option designed for a range of Ford vehicles from the early 1990s through 2008 and selected Mercury and Lincoln models. It targets the cruise-control cutout brake switch assembly—an electrical sensor that tells the vehicle when the brake is applied—so drivers can address cruise control failures or intermittent disengagements without replacing the entire pedal assembly.

How does this kit address cruise control cutout problems?

The kit provides the parts needed to replace the damaged or worn switch contacts that interrupt the cruise control circuit when the brake pedal is pressed. Replacing the switch restores the intended electrical signal that informs the cruise control module the brakes are engaged, which often clears faults and prevents unintended shutoff.

• Direct-fit part numbers SW6350, 1L1Z9F924AA, CCR1, F4044, 1S5288 for easy match.
• Replaces worn contacts and sensor components that fail over time.
• Designed to plug into original mounting points for a straightforward swap.
• Helps eliminate diagnostic confusion caused by intermittent switch behavior.

Will this repair kit fit my vehicle?

The kit is compatible with many Ford full-size vans, trucks and SUVs made from 1992–2008, plus select Mercury and Lincoln models. Always verify part numbers and your vehicle’s year/model before ordering to ensure a correct match.

• Fits Ford: E-150/E-250/E-350/E-450, F-150/F-250/F-350/F-450/F-550, Ranger, Bronco, Explorer, Expedition, Explorer Sport Trac.
• Also compatible with Mercury Mountaineer and Lincoln Navigator, Blackwood, Aviator.
• Cross-references OEM numbers for accurate identification.
• Confirm compatibility with your VIN or factory part lookup when in doubt.

How difficult is installation and what tools are required?

Installation is typically straightforward for someone comfortable with basic brake-pedal or dash electrical work; the kit is designed to replace only the switch assembly components. Follow the included reference image or a vehicle-specific repair manual to avoid misrouting wires or disturbing other pedal components.

• Basic hand tools: screwdrivers, pliers, possible small socket set.
• No major disassembly of the pedal box is usually required—follow pictured steps.
• If brake fluid leak is present, address seals and hydraulic lines as a separate repair.
• Allow time for careful alignment and electrical connection verification before testing.

What should I expect after installing the kit?

After correct installation, cruise control engagement should behave normally: it will disengage when the brake pedal is pressed and remain stable otherwise. If issues persist, further diagnosis of related wiring, the cruise control module, or brake-light circuits may be necessary.

• Restore reliable brake-switch signaling to the cruise-control system.
• Reduce false cutouts caused by intermittent switch contacts.
• Testing the system immediately after install ensures proper function.
• May eliminate the need for a full pedal assembly replacement in many cases.

Who is this for: This XINRINTONG repair kit is intended for DIY mechanics, independent repair shops, and vehicle owners maintaining older Ford, Mercury, or Lincoln models who need a targeted, cost-effective fix for cruise control cutout issues. It’s a practical choice when the brake-switch sensor is suspected to be the root cause and you want a direct replacement using common tools rather than a full pedal assembly replacement. Always confirm fitment against your vehicle’s part numbers or consult a professional if uncertain.