Xuhal LED Load Resistors 20-Pack — 50W 6Ω Gold Inline Kit to Stop Hyper-Flash & Error Codes

Xuhal 50W 6Ω load resistors (20-pack) are inline electrical resistors designed to stop LED turn-signal hyper-flashing, error codes, and flicker by adding the correct load to your vehicle's circuit.

These compact alloy resistors provide a straightforward, hardware-level solution when swapping incandescent bulbs for LEDs triggers fast flash rates or dashboard bulb-out warnings. Supplied in a bundle of 20 with T-tap connectors, the kit is intended for DIY installation on most 12V vehicle lighting circuits including turn signals, parking lights, tail lights, license lights and DRLs. Each resistor is rated 50 watts at 6 ohms and finished in a gold-colored housing for corrosion resistance and heat handling.

How do these resistors stop LED fast-flashing and error codes?

LED bulbs draw far less current than incandescent lamps, which can cause the vehicle’s flasher relay or body control module to interpret the lower load as a burnt bulb. The Xuhal resistors recreate the electrical load of a filament bulb so the system registers normal current and restores correct flash timing and warning behavior. They are wired in parallel with the LED lamp and positioned between the positive feed and ground.

• Adds equivalent resistance to increase circuit current draw
• Prevents rapid flash rates by normalizing relay response
• Suppresses bulb-out error messages on many vehicles
• Simple parallel wiring: positive feed to resistor, other side to ground

How do I install a 50W 6Ω resistor safely?

Installation requires basic electrical skills and simple tools. Mount the resistor to a metal surface away from plastic parts and wiring harnesses because it becomes hot during operation; use the supplied T-tap connectors to tap the positive turn-signal wire and attach the resistor ground to chassis. If uncertain, consult a professional.

• Turn off power and access the turn-signal wiring harness
• Use a T-tap on the positive wire and connect the resistor lead
• Secure the ground lead to clean metal chassis for reliable grounding
• Mount resistor on a metal bracket or panel to dissipate heat

Which vehicles and lamps are these resistors compatible with?

The resistors are designed for 12V automotive systems and work with most LED turn-signal, parking, tail, license plate and daytime running lights that trigger hyper-flash or error codes. They are universal hardware components, but compatibility varies with vehicle electronics—some modern cars may require CANbus-specific solutions or software programming instead.

• Works on standard 12V systems across many makes and models
• Suitable for LED turn signals, taillights, parking and license lights
• Not a guaranteed fix for vehicles with CANbus smart modules
• 20-pack provides spare parts for multi-lamp installs or fleet use

What precautions should I take when using these load resistors?

Because each resistor dissipates significant heat at full power, avoid mounting near plastic, wiring looms, rubber hoses, or painted surfaces. Ensure secure metal mounting, use appropriate connectors, and route wiring to prevent chafing. For prolonged reliability, check mounts and connections periodically.

• Mount only to metal surfaces to manage heat safely
• Avoid contact with plastic trim, hoses or paint to prevent melting
• Use the provided T-tap connectors and tighten connections firmly
• Allow ventilation around the resistor; inspect after installation

Who is this for: The Xuhal 20-pack is ideal for DIY mechanics, car enthusiasts, installers and fleet operators who retrofit multiple LED lamps and need multiple resistors for correct flash rates and error suppression. If you install LEDs on several lights or work on several vehicles, the quantity and basic alloy construction give a cost-effective, reusable solution—just follow safe mounting and wiring practices or enlist a qualified technician when in doubt.