YAMAKATO Fuel Line Kit 3.3 ft (1/8"–1/4" ID) multi-size fuel/vacuum hose with 30 clips, oil- and ethanol-resistant

YAMAKATO's kit supplies 3.3 feet of multi-size fuel tubing (1/8"–1/4" ID) plus 30 clips for non-pressurized small-engine fuel, vapor and vacuum lines.

This compact assortment gives you five common inner-diameter sizes in a single roll and a set of clamps so you can cut, fit and secure lines for lawn equipment, generators, motorcycles, ATVs and similar machines. The tubing is formulated to resist fuels including gasoline, diesel and ethanol blends, and to tolerate a wide temperature range so it stays flexible in varied weather. It is intended for gravity- or carburetor-fed systems and other low-pressure applications, not for high-pressure fuel-injection pumps.

Which engine and equipment applications work well with this tubing?

The YAMAKATO hose is sized for small engines and fuel systems that use non-pressurized lines. It is appropriate for many outdoor and utility machines where you need to replace or route fuel, vapor or vacuum hoses.

• Lawn mowers, tillers, snow blowers and garden tractors
• Motorcycles, minibikes, dirt bikes, pit bikes and scooters
• Generators, pressure washers, trash pumps and small marine outboards
• ATVs, UTVs, go-karts and other recreational vehicles

How durable is the hose and what fluids can it handle?

The material resists oil and is rated for a broad temperature span from -22°F to 338°F, helping maintain flexibility in cold starts and heat exposure. It's designed for compatibility with gasoline, diesel, E-85 and biodiesel blends, providing a reliable conduit for fuels and vapor lines in routine conditions.

• Oil-resistant compound for fuel contact
• Wide service temperature range for climate versatility
• Compatible with ethanol-containing fuels and biodiesel blends
• Not engineered for pressurized fuel-injection systems

What sizes and quantities are included, and can I customize the length?

The kit delivers 3.3 feet of tubing in five inner-diameter sizes so you can match the hose to existing fittings and barb sizes. Each size can be trimmed to the exact length you need for routing and repairs, and the included 30 clips help secure connections quickly.

• Included IDs: 1/8" (3.5mm), 5/32" (4mm), 3/16" (4.8mm), 1/5" (5.5mm), 1/4" (6.2mm)
• Outer diameters vary to fit standard barbs and fittings
• Cut-to-length tubing for custom runs and splices
• Thirty clips to fasten and seal hose ends

How should I install and maintain these fuel lines safely?

Installation is straightforward: cut the hose square, push it fully onto the barb or fitting, then secure with a clip. Periodic inspection for cracking, hardening or soft spots helps avoid failures; replace tubing if you detect damage or fuel seepage.

• Use sharp cutter to produce clean, square ends
• Slide hose over fittings fully before applying clip
• Inspect connections regularly for wear or leaks
• Do not use on high-pressure fuel pump outlets

Who this is for: This YAMAKATO kit is aimed at DIY mechanics, landscapers, small-engine shops and recreational vehicle owners who need a compact selection of fuel and vapor hose sizes for repairs and upgrades. If you service carbureted machines, generators, small boats or off-road vehicles and require ethanol-tolerant, oil-resistant tubing that you can cut to fit, this set covers the most common inner diameters and includes clamps for immediate installation.