YM E-Bright LED Hood Light Strip

This slim LED hood beam creates a sweeping start-up animation and steady running illumination to help your vehicle stand out at night while providing an extra visual cue to other road users. Built from a soft silicone housing with heavy-duty adhesive, the strip is IP68-rated for water resistance, configurable by cutting at marked points, and powered by a simple ACC/ground wiring connection. The bundle includes the hood strip plus installation aids and a one-year quality support promise.

How does the dynamic scan start-up effect work and why does it matter?

On engine start the strip plays a left-to-right or right-to-left sweep animation that draws attention before switching to a stable light mode for driving. This motion increases your car's visibility during low-light conditions and adds a modern aesthetic without altering factory lighting circuits. The effect is automatic when hooked to an ACC source and can improve recognition by pedestrians and oncoming drivers.

• Automatic sweep animation on ACC trigger
• Switches to constant lighting while driving
• Enhances visibility and contemporary vehicle styling
• No complex control modules required

Can I install and trim the 94-inch strip to fit my vehicle?

The 240 cm strip is flexible and can be shortened only at the marked cut points, but cutting may offset the scanning alignment. It’s 0.8 cm thick, so you must ensure the hood-to-body clearance is large enough to avoid pinching when the hood closes. The strip adheres with heavy-duty nano tape and comes with a hot glue stick to reinforce trimmed ends.

• Cut only on printed mark locations
• Measure hood gap before purchase to avoid damage
• Use supplied hot glue for sealing cut ends
• Adheres with strong nano tape on both sides

Is the strip durable and weatherproof for everyday use?

The housing is IP68-rated, offering high resistance to dust and water immersion—suitable for rainy conditions and normal washing. Avoid directing high-pressure washers at the strip; wash from the side instead. Built-in short-circuit protection and silicone construction help reduce dark spots and extend service life.

• IP68 waterproof rating for wet environments
• Shock-absorbing soft silicone exterior
• Short-circuit protection for safer operation
• Guidance: avoid high-pressure water jets

How do I wire and what’s included with the kit?

Wiring is straightforward: black to ground (negative) and red to an ACC (accessory) fuse so the strip powers with ignition. A test pencil is included to identify an ACC fuse in your fuse box (it lights when power is on with the engine running). The package supplies installation helpers so you can mount and seal the strip cleanly.

• Black = negative/ground, red = ACC fuse input
• Test pencil provided to locate ACC fuse points
• Hot glue stick included for sealing and reinforcement
• One-year product quality support from YM E-Bright

Who is this for? This hood light strip is aimed at car, truck, van and boat owners seeking an easy-to-install, high-visibility accent light that combines a distinctive start-up animation with steady driving illumination. Choose this if your vehicle has adequate hood clearance and you want a durable, weather-resistant LED strip to improve nighttime recognition and add a custom look without complex electronics or permanent modifications.