Yorkim 3157 LED Bulbs 6500K White — Pack of 10, 360° High‑Output 5050 SMD for Brake/Reverse/Tail Lights

Yorkim 3157 LED bulbs are plug-and-play 6500K xenon-white replacements that deliver high-output, 360° illumination for compatible 3056/3057/3156/3157/4157 vehicle sockets.

These Yorkim LED lamps are engineered to modernize your vehicle lighting by replacing yellowish halogen bulbs with crisp, daylight-white LEDs. Each bulb uses multiple 5050 SMD chips arranged to emit uniform light around the socket, improving visibility for brake, reverse, and tail applications while creating a cleaner look. The set includes ten identical bulbs to outfit multiple lamps or keep spares on hand.

How do these bulbs improve light output compared with stock halogens?

Yorkim fixtures use eighteen 5050 chipsets per bulb to generate higher lumen output and a wider beam spread than typical halogen filaments. The result is a brighter, whiter appearance and a full 360° emission pattern that reduces dark spots.

• 18 high-quality 5050 LEDs per bulb for increased brightness
• 360-degree lighting angle for consistent coverage
• 6500K color temperature for crisp white light
• Cleaner modern aesthetic versus yellow halogen glow

Will these 3157 bulbs fit my vehicle and where are they commonly used?

These bulbs match the common socket types 3056, 3057, 3156, 3157, and 4157, which are often found in reverse, brake, tail, and some turn-signal circuits. Vehicle wiring and lamp designs vary, so confirm fitment with your owner’s manual or compare against the original bulb before installation.

• Compatible with 3056/3057/3156/3157/4157 sockets
• Typical uses: reverse lights, brake lights, tail lights, and some turn signals
• Check owner’s manual or original bulb for confirmation
• Not compatible with CK sockets

Do I need additional components to prevent errors or hyper-flashing?

Because some vehicles monitor bulb load, you may encounter dashboard error codes or fast blink rates when switching to LEDs. Adding a load resistor or an LED-compatible flasher relay resolves these issues on affected models.

• Some cars require a 50W load resistor to prevent error messages
• A flasher relay may be needed to stop fast blinking on turn signals
• Polarity-sensitive: rotate the bulb 180° if it doesn’t light initially
• Installation is typically plug-and-play otherwise

How simple is installation and what should I watch for?

Installation is straightforward: remove the original bulb and plug the Yorkim LED into the same socket. Because these LEDs are polarity-sensitive, reverse the bulb if it fails to illuminate on first insertion. Always power off the light circuit before swapping bulbs.

• Plug-and-play design for most applications
• Turn power off before replacing bulbs for safety
• If bulb does not light, rotate 180° and reinsert
• Verify each lamp location needs the 3157 form factor before replacing

Who is this for: drivers who want brighter, whiter vehicle lighting and a modernized appearance across brake, reverse, and tail lights. This ten-bulb pack suits DIY enthusiasts replacing multiple sockets, fleet owners standardizing lighting, or anyone who wants spare LED bulbs on hand. Confirm socket type and any required resistors/relays for your specific vehicle before purchase to ensure proper operation.