JUTA OBD2 DB25 Main Cable for INNOVA 3100–3170 Series — 5.1ft Shielded 16‑to‑25‑Pin Adapter

JUTA main cable is a 5.1ft (155cm) 16‑pin to 25‑pin OBD‑II adapter built to replace or extend the factory lead for INNOVA 3100–3170 series diagnostic scanners.

If your INNOVA DB25 OBD2 code reader needs a reliable replacement lead, this purpose-made main cable provides a direct, plug‑and‑play connection between the scanner and the vehicle’s OBD‑II port. Designed to match the pinout and length expected for the INNOVA 3100, 3110, 3120, 3130, 3130C, 3140, 3150, 3160, 31703, 31603, 31403 and 5610 models, it restores full communication without reprogramming.

How does this cable keep diagnostic data accurate?

The JUTA lead uses shielded conductors and high‑insulation materials to reduce electrical noise and preserve signal integrity during vehicle scans. Stable transmission lowers the chance of corrupted frames and intermittent faults while you read or clear trouble codes.

• Shielded wiring minimizes radio‑frequency and electrical interference.
• Properly matched pin configuration for DB25 OBD2 INNOVA scanners.
• Consistent 5.1ft length for convenient reach without strain.

Will this cable fit my INNOVA scanner and vehicle?

Yes — one end terminates in a standard OBD‑II 16‑pin male plug that connects to the vehicle harness, while the opposite end is a 25‑pin male DB25 that mates to the INNOVA scanner. It is intended specifically for the listed INNOVA models and standard OBD‑II equipped cars and light trucks.

• 16‑pin OBD‑II male connector for vehicle ECU access.
• 25‑pin male DB25 connector tailored for INNOVA units.
• Plug‑and‑play installation: no adapters or software changes required.

What are the build quality and durability features?

The cable is constructed from environmentally friendly materials with enhanced insulation and strain relief at each end. That combination delivers long service life even when used frequently in a shop or garage environment.

• High‑insulation jacket resists abrasion and chemical exposure.
• Reinforced connector ends reduce flex fatigue at stress points.
• Manufactured to provide consistent electrical performance over repeated uses.

How easy is it to replace my old lead or add an extra cable?

Replacement is straightforward: unplug the old DB25 lead from your INNOVA scanner and plug this cable in — then connect the 16‑pin to your vehicle port. Its length and flexible jacket make positioning the scanner convenient while you work.

• No tools or pairing needed; immediate recognition by the scanner.
• 5.1ft length balances reach and cable management in most vehicles.
• Strong anti‑interference properties reduce need for repeat attempts.

Who is this for: technicians, DIY mechanics, and fleet staff who own or operate INNOVA 3100–3170 series DB25 diagnostic scanners and need a dependable replacement or spare main cable. It suits anyone wanting a rugged, OEM‑compatible connection that preserves scan accuracy and reduces troubleshooting time.